 |
|
Tiny Flares Responsible for Outsized Heat of Sun's Atmosphere
August 17, 2009"Why is the sun's corona so darned hot?" asks James Klimchuk, an astrophysicist at the Goddard Space Flight Center's Solar Physics Laboratory in Greenbelt, Md.
The mystery of why temperatures in the solar corona, the sun's outer atmosphere, soar to several million degrees Kelvin (K) -much hotter than temperatures nearer the sun's surface-has puzzled scientists for decades. New observations made with instruments aboard Japan's Hinode satellite reveal the culprit to be nanoflares.
Nanoflares are small, sudden bursts of heat and energy. "They occur within tiny strands that are bundled together to form a magnetic tube called a coronal loop," says Klimchuk. Coronal loops are the fundamental building blocks of the thin, translucent gas known as the sun's corona.
Scientists previously thought steady heating explained the corona's million degree temperatures. The steady heating model indicates that a coronal loop of a given length and temperature should have a specific density. However, observations showed that coronal loops have much higher density than the steady heating model predicts. Newer models based on nanoflares can explain the observed density. But no direct evidence of the nanoflares existed until now.
Observations from the NASA-funded X-Ray Telescope (XRT) and Extreme-ultraviolet Imaging Spectrometer (EIS) instruments aboard Hinode reveal that ultra-hot plasma is widespread in solar active regions. The XRT measured plasma at 10 million degrees K, and the EIS measured plasma at 5 million degrees K. "These temperatures can only be produced by impulsive energy bursts,"says Klimchuk, who presented the findings on August 6 at the International Astronomical Union General Assembly meeting in Rio de Janeiro, Brazil.
"Coronal loops are bundles of unresolved strands that are heated by storms of nanoflares."
Coronal heating is a dynamic process. The brightness of the observed X-ray and ultraviolet emission is strongly dependent on the density of the coronal plasma. Where there's low density, there isn't much brightness. Where there's high density, there's a lot of brightness. The corona is mostly bright at about 1 million degrees K.
Klimchuk and colleagues constructed a theoretical model to explain how plasma evolves within these coronal tubes and what causes temperatures to skyrocket. "We simulate a burst of heating and see how the corona responds," says Klimchuk. "Then we make predictions about how much emission we should see from plasma of different temperatures."
Klimchuk surmises that when a nanoflare suddenly releases its energy, the plasma in the low-temperature, low-density strands becomes very hot-around 10 million degrees K-very quickly. The density remains low, however, so the emission, or brightness, remains faint. Heat flows from up in the strand, where it's hot, down to the base of the coronal loop, where it's not as hot. This heats up the dense plasma at the loop's base. Because it is so dense at the base, the temperature only reaches about 1 million degrees K. This dense plasma expands up into the strand. Thus, a coronal loop is a collection of 5-10 million degree K faint strands and 1 million degree K bright strands.
"What we see is 1 million degree K plasma that has received its energy from the heat flowing down from the superhot plasma," says Klimchuk. "For the first time, we have detected this 10 million degree plasma, which can only be produced by the impulsive energy bursts of nanoflares."
The Hinode observations and the scientists' analysis verify that nanoflares are occurring on the sun and that they explain much and perhaps most coronal heating. The observations also confirm "there is some nanoflare activity everywhere" in the sun's active regions, says Klimchuk.
Nanoflares are responsible for changes in the X-ray and ultraviolet (UV) radiation that happen as an active region evolves. X-ray and UV get absorbed by Earth's upper atmosphere, which heats up and expands. Changes in the upper atmosphere can affect the orbits of satellites and space debris by slowing them down, an effect known as "drag." It is important to know the changing orbits so that maneuvers can be made to avoid space collisions. The X-ray and UV also affect the propagation of radio signals and thereby adversely affect communication and navigation systems.
The discovery that nanoflares play an important and perhaps dominant role in coronal heating paves the way to understanding how the sun affects Earth, our place in the universe.
NASA Goddard Space Flight Center
Scientists previously thought steady heating explained the corona's million degree temperatures. The steady heating model indicates that a coronal loop of a given length and temperature should have a specific density. However, observations showed that coronal loops have much higher density than the steady heating model predicts. Newer models based on nanoflares can explain the observed density. But no direct evidence of the nanoflares existed until now.
Observations from the NASA-funded X-Ray Telescope (XRT) and Extreme-ultraviolet Imaging Spectrometer (EIS) instruments aboard Hinode reveal that ultra-hot plasma is widespread in solar active regions. The XRT measured plasma at 10 million degrees K, and the EIS measured plasma at 5 million degrees K. "These temperatures can only be produced by impulsive energy bursts,"says Klimchuk, who presented the findings on August 6 at the International Astronomical Union General Assembly meeting in Rio de Janeiro, Brazil.
"Coronal loops are bundles of unresolved strands that are heated by storms of nanoflares."
Coronal heating is a dynamic process. The brightness of the observed X-ray and ultraviolet emission is strongly dependent on the density of the coronal plasma. Where there's low density, there isn't much brightness. Where there's high density, there's a lot of brightness. The corona is mostly bright at about 1 million degrees K.
Klimchuk and colleagues constructed a theoretical model to explain how plasma evolves within these coronal tubes and what causes temperatures to skyrocket. "We simulate a burst of heating and see how the corona responds," says Klimchuk. "Then we make predictions about how much emission we should see from plasma of different temperatures."
Klimchuk surmises that when a nanoflare suddenly releases its energy, the plasma in the low-temperature, low-density strands becomes very hot-around 10 million degrees K-very quickly. The density remains low, however, so the emission, or brightness, remains faint. Heat flows from up in the strand, where it's hot, down to the base of the coronal loop, where it's not as hot. This heats up the dense plasma at the loop's base. Because it is so dense at the base, the temperature only reaches about 1 million degrees K. This dense plasma expands up into the strand. Thus, a coronal loop is a collection of 5-10 million degree K faint strands and 1 million degree K bright strands.
"What we see is 1 million degree K plasma that has received its energy from the heat flowing down from the superhot plasma," says Klimchuk. "For the first time, we have detected this 10 million degree plasma, which can only be produced by the impulsive energy bursts of nanoflares."
The Hinode observations and the scientists' analysis verify that nanoflares are occurring on the sun and that they explain much and perhaps most coronal heating. The observations also confirm "there is some nanoflare activity everywhere" in the sun's active regions, says Klimchuk.
Nanoflares are responsible for changes in the X-ray and ultraviolet (UV) radiation that happen as an active region evolves. X-ray and UV get absorbed by Earth's upper atmosphere, which heats up and expands. Changes in the upper atmosphere can affect the orbits of satellites and space debris by slowing them down, an effect known as "drag." It is important to know the changing orbits so that maneuvers can be made to avoid space collisions. The X-ray and UV also affect the propagation of radio signals and thereby adversely affect communication and navigation systems.
The discovery that nanoflares play an important and perhaps dominant role in coronal heating paves the way to understanding how the sun affects Earth, our place in the universe.
NASA Goddard Space Flight Center
Astrophysicists Listen to Loops Shivering on the Sun
You would imagine that a 500,000 kilometre long arch of super heated plasma releasing energy equal to the simultaneous explosion of 40 billion Hiroshima atomic bombs would be as easy to "hear" as it is to "see" - but it's not. Astrophysicists have long thought about using the acoustic waves in these flares to understand more about these gigantic events, that can be dozens of times bigger than the Earth, but have been unable to use effectively up till now. Now researchers at the University of Warwick, and Lockheed Martin's Solar and Astrophysics lab in Palo Alto, have found a way to "listen" to how these gigantic loops "shiver" - vastly increasing our abili
External Magnetic Field Causes The Puzzling Heating Of The Solar Corona
The Russian astrophysicists have theoretically modelled coronal loop oscillations and have shown that the plasma present in coronal loops is quite "normal". So, the puzzle of the Sun`s atmosphere heating remains unresolved. Coronal loops, immense magnetic arches more hot and dense than the coronal gas, are formed by magnetic fields. They are anchored in the Sun`s visible surface rising up to 100 - 200 thousand kilometres. In the active regions of the Sun these loops, which are 1000 - 3000 kilometres in diameter, form bunches and tangles. In 1998 the American Transition Region and Coronal Explore
More Coronal Loop Current Events and Coronal Loop News Articles
| © 2009 BrightSurf.com |