Optical scanner design for adaptive driving beam systems can lead to safer night driving

January 27, 2021

Car accidents are responsible for approximately a million deaths each year globally. Among the many causes, driving at night, when vision is most limited, leads to accidents with higher mortality rates than accidents during the day. Therefore, improving visibility during night driving is critical for reducing the number of fatal car accidents.

An adaptive driving beam (ADB) can help to some extent. This advanced drive-assist technology for vehicle headlights can automatically adjust the driver's visibility based on the car speed and traffic environment. ADB systems that exist commercially are a marked improvement over manually controlled headlights, but they suffer from limited controllability. Whereas spatial light modulators, like liquid crystal pixels or digital micromirrors, can alleviate this problem, they are often expensive to implement and lead to heat loss from unutilized light power.

In a recent study published in the , researchers from Japan have come up with an alternative to conventional ADB systems: a microelectromechanical systems (MEMS) optical scanner that relies on the piezoelectric effect of electrically induced mechanical vibrations. This design consists of a thin film of lead-zirconate-titanate oxide (or PZT), which induces mechanical vibrations in the scanner in synchronization with a laser diode. The optical scanner spatially steers the laser beam to form structured light on the phosphor plate, where it is converted into bright white light. The light intensity is, in turn, modulated by the ADB controller based on the traffic, steering wheel angle, and vehicle cruising speed. University of Tokyo researcher Hiroshi Toshiyoshi, one of the authors on the paper, explains, "What is unique about this setup is that the laser beam is converted into white light at high efficiency, which reduces heating of the ADB system."

The researchers designed the optical scanner on a single chip consisting of a bonded silicon-on-insulator wafer with the PZT layer grown on it and laminated with metal to form piezoelectric actuators. They arranged the actuators as suspensions to allow for large-angle horizontal and vertical deflections of the scanner. This, in turn, enabled two-dimensional scanning of the headlight beam. Further, they designed the modes so that they don't react to low-frequency noise, such as from other vehicles. Their ADB system also accounts for temperature variations. Finally, they mounted the module on a vehicle and evaluated its performance for actual driving.

The researchers found that the ADB with a MEMS scanner provided the driver with better visibility, especially when it comes to seeing pedestrians. It could also reduce the glare from oncoming vehicles and reconfigure the illumination area depending on the cruising speed of the vehicle.

While this technology certainly advances drive-assist technology, it also has other potential applications in light detection and range finding, as well as inter-vehicle optical communication links, which means that the system could find use in self-driving technology of intelligent traffic systems in the future, taking us another step toward risk-free driving.
-end-
Read the original Gold Open Access article: T. Asari et al.,
J. Opt. Microsys. 1(1), 014501 (2021), doi:
SPIE--International Society for Optics and Photonics

Related Driving Articles from Brightsurf:

Driving behavior less 'robotic' thanks to new Delft model
Researchers from TU Delft have now developed a new model that describes driving behaviour on the basis of one underlying 'human' principle: managing the risk below a threshold level.

Warming temperatures are driving arctic greening
As Arctic summers warm, Earth's northern landscapes are changing. Using satellite images to track global tundra ecosystems over decades, a new study found the region has become greener, as warmer air and soil temperatures lead to increased plant growth.

Software of autonomous driving systems
Researchers at TU Graz and AVL focus on software systems of autonomous driving systems.

Driving immunometabolism to control lung infection
When drugs to kill microbes are ineffective, host-directed therapy uses the body's own immune system to deal with the infection.

Representation of driving behavior as a statistical model
A joint research team from Toyohashi University of Technology has established a method to represent driving behaviors and their changes that differ among drivers in a single statistical model, taking into account the effect of various external factors such as road structure.

Improving the vision of self-driving vehicles
There may be a better way for autonomous vehicles to learn how to drive themselves: by watching humans.

Impaired driving -- even once the high wears off
McLean researchers have discovered that recreational marijuana use affects driving ability even when users are not intoxicated.

Self-driving microrobots
Most synthetic materials, including those in battery electrodes, polymer membranes, and catalysts, degrade over time because they don't have internal repair mechanisms.

AI to determine when to intervene with your driving
Can your AI agent judge when to talk to you while you are driving?

Cooperating may result in better self-driving experience
To better understand and predict the outcomes of the steering wheel control dilemma, contrary to many previous studies, in a paper published in IEEE/CAA Journal of Automatica Sinica, Dr.

Read More: Driving News and Driving Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.