3D-printed spectrometer on a 100 x100 μm² footprint

February 08, 2021

Femtosecond direct laser writing as a 3D printing technology has been one of the key building blocks for miniaturization in modern times. It has transformed the field of complex microoptics since the early 2000s. Especially medical engineering and consumer electronics as vastly growing fields benefit from these developments. It is now possible to create robust, monolithic and nearly perfectly aligned freeform optical systems on almost arbitrary substrates such as image sensors or optical fibers.

Simultaneously, the miniaturisation of spectroscopic measurement devices has been advanced, for instance based on quantum dot or nanowire technology. These are based on computational approaches, which have the drawback of being calibration sensitive and require complex reconstruction algorithms.

In a new paper published in Light: Advanced Manufacturing, a team of scientists, led by Professor Alois Herkommer from the Institute of Applied Optics and Professor Giessen from the 4th Physics Institute, University of Stuttgart, Germany, have demonstrated an angle-insensitive 3D-printed miniature spectrometer with a direct separated spatial-spectral response. It has a volume of less than 100 × 100 × 300 μm³.

The design is based on a classical grating spectrometer and was fabricated via two-photon direct laser writing combined with a super-fine inkjet process. Its tailored and chirped high-frequency grating enables strongly dispersive behavior. The miniature spectrometer features a wavelength range in the visible from 490 nm to 690 nm. It has a spectral resolution of 9.2 ± 1.1 nm at 532 nm and 17.8 nm ± 1.7 nm at a wavelength of 633 nm. Leading author Andrea Toulouse assesses the potential as:

"With its volume of less than 100 × 100 × 300 μm³ we explore a whole new size range for direct spectrometers. An order of magnitude this small could only be realised by computational approaches until now. In contrast, we translate the spectrum directly into a spatially encoded intensity signal which can be read out with a commercial monochromatic image sensor."

"For 3D-printed microoptics, the complexity of the optical design marks an innovation. Refractive, diffractive and spatially filtering elements have never been combined in such a small volume to create a complex and monolithic measurement system."

"Our spectrometer could be fabricated directly on a miniature image sensor as the tip of a distal chip endoscope. This way, regions in the human body could be examined with extremely high bending radii that were not accessible before" the scientists forecast. "It could also be an interesting approach for hyperspectral imaging where the spectrometer would be used as a unit cell (macro pixel). The redistribution of spectral energy instead of high-loss Fabry-Perot-filtering could thus enable highly efficient hyperspectral imaging sensors. The ever-growing world population could benefit from such a camera if it was used for spectral mapping in precision farming, for instance."
-end-


Light Publishing Center, Changchun Institute of Optics, Fine Mechanics And Physics, CAS

Related Spectrometer Articles from Brightsurf:

Researchers shrink imaging spectrometer without compromising performance
Researchers have developed a new imaging spectrometer that is much lighter and smaller than state-of-the-art instruments while maintaining the same high level of performance.

Turning excess noise into signal
Excess noise fluctuations of light are widely considered to be detrimental in optics and photonics.

New method uses noise to make spectrometers more accurate
Optical spectrometers are instruments with a wide variety of uses.

Comet Chury's ultraviolet aurora
On Earth, auroras, also called northern lights, have always fascinated people.

Structure of 'immortality protein' now better understood
A key role in studying the telomerase of Hansenula polymorpha was played by KFU's nuclear magnetic resonance spectrometer.

Status report: OSIRIS-REx completes closest flyover of sample site nightingale
OSIRIS-REx successfully executed a 0.4-mile (620-m) flyover of site Nightingale yesterday as part of the mission's Reconnaissance B phase activities.

The salt of the comet
Under the leadership of astrophysicist Kathrin Altwegg, Bernese researchers have found an explanation for why very little nitrogen could previously be accounted for in the nebulous covering of comets: the building block for life predominantly occurs in the form of ammonium salts, the occurrence of which could not previously be measured.

Smaller than a coin
ETH researchers have developed a compact infrared spectrometer. It's small enough to fit on a computer chip but can still open up interesting possibilities -- in space and in everyday life.

Natural-gas leaks are important source of greenhouse gas emissions in Los Angeles
Liyin He, a Caltech graduate student, finds that methane in L.A.'s air correlates with the seasonal use of gas for heating homes and businesses

Fiber-based imaging spectrometer captures record amounts of data
Researchers have developed a new compact, fiber-based imaging spectrometer for remote sensing that can capture 30,000 sampling points each containing more than 60 wavelengths.

Read More: Spectrometer News and Spectrometer Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.