System draws power from daily temperature swings

February 15, 2018

CAMBRIDGE, Mass. - Thermoelectric devices, which can generate power when one side of the device is a different temperature from the other, have been the subject of much research in recent years. Now, a team at MIT has come up with a novel way to convert temperature fluctuations into electrical power. Instead of requiring two different temperature inputs at the same time, the new system takes advantage of the swings in ambient temperature that occur during the day-night cycle.

The new system, called a thermal resonator, could enable continuous, years-long operation of remote sensing systems, for example, without requiring other power sources or batteries, the researchers say.

The findings are being reported in the journal Nature Communications, in a paper by graduate student Anton Cottrill, Carbon P. Dubbs Professor of Chemical Engineering Michael Strano, and seven others in MIT's Department of Chemical Engineering.

"We basically invented this concept out of whole cloth," Strano says. "We've built the first thermal resonator. It's something that can sit on a desk and generate energy out of what seems like nothing. We are surrounded by temperature fluctuations of all different frequencies all of the time. These are an untapped source of energy."

While the power levels generated by the new system so far are modest, the advantage of the thermal resonator is that it does not need direct sunlight; it generates energy from ambient temperature changes, even in the shade. That means it is unaffected by short-term changes in cloud cover, wind conditions, or other environmental conditions, and can be located anywhere that's convenient -- even underneath a solar panel, in perpetual shadow, where it could even allow the solar panel to be more efficient by drawing away waste heat, the researchers say.

The thermal resonator was shown to outperform an identically sized, commercial pyroelectric material -- an established method for converting temperature fluctuations to electricity -- by factor of more than three in terms of power per area, according to Cottrill.

The researchers realized that to produce power from temperature cycles, they needed a material that is optimized for a little-recognized characteristic called thermal effusivity -- a property that describes how readily the material can draw heat from its surroundings or release it. Thermal effusivity combines the properties of thermal conduction (how rapidly heat can propagate through a material) and thermal capacity (how much heat can be stored in a given volume of material). In most materials, if one of these properties is high, the other tends to be low. Ceramics, for example, have high thermal capacity but low conduction.

To get around this, the team created a carefully tailored combination of materials. The basic structure is a metal foam, made of copper or nickel, which is then coated with a layer of graphene to provide even greater thermal conductivity. Then, the foam is infused with a kind of wax called octadecane, a phase-change material, which changes between solid and liquid within a particular range of temperatures chosen for a given application.

A sample of the material made to test the concept showed that, simply in response to a 10-degree-Celsius temperature difference between night and day, the tiny sample of material produced 350 millivolts of potential and 1.3 milliwatts of power -- enough to power simple, small environmental sensors or communications systems.

"The phase-change material stores the heat," says Cottrill, the study's lead author, "and the graphene gives you very fast conduction" when it comes time to use that heat to produce an electric current.

Essentially, Strano explains, one side of the device captures heat, which then slowly radiates through to the other side. One side always lags behind the other as the system tries to reach equilibrium. This perpetual difference between the two sides can then be harvested through conventional thermoelectrics. The combination of the three materials -- metal foam, graphene, and octadecane -- makes it "the highest thermal effusivity material in the literature to date," Strano says.

While the initial testing was done using the 24-hour daily cycle of ambient air temperature, tuning the properties of the material could make it possible to harvest other kinds of temperature cycles, such as the heat from the on-and-off cycling of motors in a refrigerator, or of machinery in industrial plants.

"We're surrounded by temperature variations and fluctuations, but they haven't been well-characterized in the environment," Strano says. This is partly because there was no known way to harness them.

Other approaches have been used to try to draw power from thermal cycles, with pyroelectric devices, for example, but the new system is the first that can be tuned to respond to specific periods of temperature variations, such as the diurnal cycle, the researchers say.

These temperature variations are "untapped energy," says Cottrill, and could be a complementary energy source in a hybrid system that, by combining multiple pathways for producing power, could keep working even if individual components failed. The research was partly funded by a grant from Saudi Arabia's King Abdullah University of Science and Technology (KAUST), which hopes to use the system as a way of powering networks of sensors that monitor conditions at oil and gas drilling fields, for example.

"They want orthogonal energy sources," Cottrill says -- that is, ones that are entirely independent of each other, such as fossil fuel generators, solar panels, and this new thermal-cycle power device. Thus, "if one part fails," for example if solar panels are left in darkness by a sandstorm, "you'll have this additional mechanism to give power, even if it's just enough to send out an emergency message."

Such systems could also provide low-power but long-lasting energy sources for landers or rovers exploring remote locations, including other moons and planets, says Volodymyr Koman, an MIT postdoc and co-author of the new study. For such uses, much of the system could be made from local materials rather than having to be premade, he says.
-end-
The team also included MIT chemical engineering graduate students Albert Tianxiang Liu, Amir Kaplan, and Sayalee Mahajan; visiting scientist Yuichiro Kunai; postdoc Pingwei Liu; and undergraduate Aubrey Toland. It was supported by the Office of Naval Research, KAUST, and the Swiss National Science Foundation.

Massachusetts Institute of Technology

Related Solar Panels Articles from Brightsurf:

Multi-institutional team extracts more energy from sunlight with advanced solar panels
Researchers working to maximize solar panel efficiency said layering advanced materials atop traditional silicon is a promising path to eke more energy out of sunlight.

Thin-skinned solar panels printed with inkjet
Efficient, yet exceptionally light organic solar cells created entirely by inkjet printing.

Green energy and better crops: Tinted solar panels could boost farm incomes
Researchers have demonstrated the use of tinted, semi-transparent solar panels to generate electricity and produce nutritionally-superior crops simultaneously, bringing the prospect of higher incomes for farmers and maximising use of agricultural land.

NREL research points to strategies for recycling of solar panels
Researchers at the National Renewable Energy Laboratory (NREL) have conducted the first global assessment into the most promising approaches to end-of-life management for solar photovoltaic (PV) modules.

Merging solar cell and liquid battery produces long-lasting solar storage
Combining liquid chemical battery technology with perovskite solar cells has led to a new record in solar energy conversion within a single device.

Merging solar cell and liquid battery produces efficient, long-lasting solar storage
Chemists at the University of Wisconsin-Madison and their collaborators have created a highly efficient and long-lasting solar flow battery, a way to generate, store and redeliver renewable electricity from the sun in one device.

Trapping the Sun: New thin-film technology uses sustainable components for solar panels
Most common thin-film solar panels consist of expensive rare-earth elements like indium and gallium, or highly toxic metals like cadmium.

"Bright spot" during COVID-19: Increased power from solar panels thanks to cleaner air
During the COVID-19 pandemic, one unexpected outcome in cities around the world has been a reduction in air pollution, as people stay home to avoid contracting the coronavirus.

Double-sided solar panels that follow the sun prove most cost effective
Solar power systems with double-sided (bifacial) solar panels--which collect sunlight from two sides instead of one--and single-axis tracking technology that tilts the panels so they can follow the sun are the most cost effective to date, researchers report in the journal Joule.

Moisture-sucking gels give solar panels the chills
Polymers that absorb water from the atmosphere can make it easier to run photovoltaic devices in hot climates.

Read More: Solar Panels News and Solar Panels Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.