Nav: Home

Separating charge and discharge in measuring next-generation car batteries

March 29, 2016

WASHINGTON, D.C., March 29, 2016 -- Lithium ion phosphate batteries are widely used to power the batteries in electric cars, but, unlike the amount of gas in a fuel tank, their state of charge can't be measured directly by a physical quantity. Instead, they use an algorithm based on measurements of battery voltage and current, which are in turn influenced by conditions such as weather, electrovoltaic state and traffic conditions. However, the algorithms currently used to measure state of charge each carry drawbacks when used in real-time applications.

To better estimate the state of charge in lithium ion phosphate batteries, researchers at Southwest Jiaotong University in Chengdu, China, have recently developed an algorithm that can separately measure the charging and discharging states of the battery. This allows it to function amidst initial inaccurate values and errors in measuring current, as well as distinguish between the performance of each battery in the series.

According to Zhu Xu, a researcher at Southwest Jiaotong University's School of Electrical Engineering, the differences of dynamic characteristics among batteries in series - such as battery capacity, internal resistance and polarization resistance - can cause the state of charge to become unbalanced, which influences the efficiency and lifespan of the battery packs.

Xu and her colleagues discuss their improved Thenevin circuit model this week in The Journal of Renewable and Sustainable Energy, from AIP Publishing. The previous work has involved lithium battery management chips and management systems.

The initial value of a battery's state of charge is generally calculated by the open-circuit voltage method, which is based on the relationship between the state of charge and the difference of electrical potential between the device's terminals when disconnected from a circuit. According to Xu, however, this relationship can only be experimentally observed, which carries unavoidable experimental error. Additionally, she said, this relationship could potentially be shifted by the charging and discharging conditions.

The traditional algorithms for estimating a battery's state of charge - Ampere-hour integration, the open-circuit voltage method, neural network modeling and Kalman filtering - all carry drawbacks. Ampere-hour integration, while the most commonly used method, relies heavily on the initial state-of-charge value; the open-circuit voltage method can only be used to estimate initial state of charge; neural network modeling places a massive demand on a microprocessor to estimate multiple state-of-charge values using a large amount of experimental data; Kalman filtering, while effective at estimating the current of time-varying states in a dynamic system even amidst initial incorrect values, highly relies on the accuracy of the battery models.

This can become problematic in a traditional Thevenin equivalent circuit model. In these model circuits, the same internal and polarization resistances are adopted when the battery is being charged and discharged. In practice, however, these characteristics end up varying significantly between the two states, which can lead to inaccuracies - making Kalman filtering less than ideal.

To remedy this, the researcher's improved Thevenin equivalent circuit model works by offering different current paths when the battery is being charged or discharged. This allows the researchers to model the characteristics of the battery separately under charging and discharging conditions, with the added ability of the Kalman filter to estimate the battery's state of charge amidst incorrect initial values.

"The proposed improved Thevenin equivalent circuit battery model and state-of-charge estimation algorithm can estimate the battery's state-of-charge more accurately, without many unwanted disturbances," Xu said.

Future work for Xu Zhu and her colleagues includes developing systems to measure a battery system's state of health, which in its current operating conditions is expressed as percentage of ideal performance.
-end-
The article, "LiFePO4 battery state of charge estimation based on the improved Thevenin equivalent circuit model and Kalman filtering," is authored by Zhu Xu, Shibin Gao and Shunfeng Yang. It was published in the Journal of Renewable and Sustainable Energy March 29, 2016 (DOI: 10.1063/1.4944335) and can be accessed at http://scitation.aip.org/content/aip/journal/jrse/8/2/10.1063/1.4944335.

ABOUT THE JOURNAL

Journal of Renewable and Sustainable Energy is an interdisciplinary, peer-reviewed journal covering all areas of renewable and sustainable energy that apply to the physical science and engineering communities. http://jrse.aip.org

American Institute of Physics

Related Batteries Articles:

A seaweed derivative could be just what lithium-sulfur batteries need
Lithium-sulfur batteries have great potential as a low-cost, high-energy, energy source for both vehicle and grid applications.
Batteries from scrap metal
Chinese scientists have made good use of waste while finding an innovative solution to a technical problem by transforming rusty stainless steel mesh into electrodes with outstanding electrochemical properties that make them ideal for potassium-ion batteries.
Better cathode materials for lithium-sulphur-batteries
A team at the Helmholtz-Zentrum Berlin (HZB) has for the first time fabricated a nanomaterial made from nanoparticles of a titanium oxide compound (Ti4O7) that is characterized by an extremely large surface area, and tested it as a cathode material in lithium-sulphur batteries.
Bright future for self-charging batteries
Who hasn't lived through the frustrating experience of being without a phone after forgetting to recharge it?
Making batteries from waste glass bottles
Researchers at the University of California, Riverside's Bourns College of Engineering have used waste glass bottles and a low-cost chemical process to create nanosilicon anodes for high-performance lithium-ion batteries.
Batteries -- quick coatings
Scientists at Oak Ridge National Laboratory are using the precision of an electron beam to instantly adhere cathode coatings for lithium-ion batteries -- a leap in efficiency that saves energy, reduces production and capital costs, and eliminates the use of toxic solvents.
Lighter, more efficient, safer lithium-ion batteries
Researchers from Universidad Carlos III de Madrid and the Council for Scientific Research (initialed CSIC in Spanish) have patented a method for making new ceramic electrodes for lithium-ion batteries that are more efficient, cheaper, more resistant and safer than conventional batteries.
Clarifying how lithium ions ferry around in rechargeable batteries
IBS scientists observe the real-time ultrafast bonding of lithium ions with the solvents, in the same process that happens during charging and discharging of lithium batteries, and conclude that a new theory is needed.
A new approach to improving lithium-sulfur batteries
Researchers from the University of Delaware and China's Northwestern Polytechnical University, Shenzhen University and Hong Kong Polytechnic University have demonstrated a new polysulfide entrapping strategy that greatly improves the cycle stability of Li-S batteries.
Looking for the next leap in rechargeable batteries
USC researchers may have just found a solution for one of the biggest stumbling blocks to the next wave of rechargeable batteries -- small enough for cellphones and powerful enough for cars.

Related Batteries Reading:

Best Science Podcasts 2019

We have hand picked the best science podcasts for 2019. Sit back and enjoy new science podcasts updated daily from your favorite science news services and scientists.
Now Playing: TED Radio Hour

Anthropomorphic
Do animals grieve? Do they have language or consciousness? For a long time, scientists resisted the urge to look for human qualities in animals. This hour, TED speakers explore how that is changing. Guests include biological anthropologist Barbara King, dolphin researcher Denise Herzing, primatologist Frans de Waal, and ecologist Carl Safina.
Now Playing: Science for the People

#532 A Class Conversation
This week we take a look at the sociology of class. What factors create and impact class? How do we try and study it? How does class play out differently in different countries like the US and the UK? How does it impact the political system? We talk with Daniel Laurison, Assistant Professor of Sociology at Swarthmore College and coauthor of the book "The Class Ceiling: Why it Pays to be Privileged", about class and its impacts on people and our systems.