'FLARE' For Fire Research Leads To New Detector

August 21, 1997

WEST LAFAYETTE, Ind. -- Purdue University engineers have developed a new type of fire detector that senses temperature to detect flames, and that has several advantages over conventional smoke detectors.

"One advantage of this device is that it doesn't have to be 'looking' directly at the flame to 'see' it," says Jay Gore, a professor of mechanical engineering at Purdue who specializes in combustion research.

"It can pick up reflections from a fire off the walls, so it can directly survey a multiple-room enclosure for fire from a single location. This gives it a very fast response time compared to a smoke detector, which doesn't go off until smoke has traveled to it -- a delay that can be several minutes." Because the new detector is very sensitive, Gore says, it may first be used in large warehouses, but it also will benefit the home.

Gore and Yudaya Sivathanu, a Purdue research scientist, developed the new detector with the help of a two-year research grant from the Center for Fire Research at the National Institute of Standards and Technology (NIST).

Because the new device uses fiber optics to detect radiation from a fire, optical fibers could easily be run from a central detection unit to each room in a multistory building, Gore says, providing "blanket" coverage.

Also, the Purdue device would benefit those people who periodically turn off their smoke detectors to avoid a false alarm. The Purdue engineers say their device would cut down on false alarms because it doesn't respond to common household occurrences, such as a hot plate or an overcooked hamburger.

The prototype detector is bulky, but Sivathanu has established a small business, En'Urga Inc., at Purdue's Business and Technology Center to develop the detector for industrial and commercial use within the next three to five years. Sivathanu presented information on the new detector Aug. 15 at the Second International Conference on Fire Research and Engineering in Gaithersburg, Md.

The device, which detects the characteristic light given off by an uncontrolled flame, could be hooked into a telephone or personal computer to automatically notify the fire department and give off audio safety instructions when a fire starts, Gore says.

"If the device were connected to a personal computer, as we have it in the lab, the computer can be programmed to repeat safety instructions to people in the house, such as 'Stay close to the floor,' or 'Crawl to the nearest door,'" Gore says. "This can be very helpful in an emergency, when people may be panicking, but it is especially important for small children who are frightened by scary, loud alarms. It could be very calming to hear a parent's voice, even if it is coming from the computer.

"I believe that in the next few years, the home PC will control the home security and safety systems and that a fiber optic communication network will carry such signals in addition to voice and data. This detector could be easily integrated into such a communications network."

The wavelengths of light that the detector picks up are in the near infrared -- in other words, heat. "The idea of using heat to detect fires is not new, but we have applied a unique discrimination algorithm to the process to eliminate false alarms," says Gore, whose previous research on different types of flames helped NIST researchers in their analysis of oil well fires in Kuwait.

Over the past two years, as they were developing the detector, Sivathanu, Gore and their graduate students examined the near-infrared radiation given off by several "standard" types of fires. These type of fires cover a wide range of combustible materials.

"We have analyzed flames based on the way the intensity of the light fluctuates as they burn," Gore explains. "For example, we may see a peak in intensity every tenth of a second, and then the pattern is repeated. That type of fluctuation frequency is characteristic of an uncontrolled fire."

Once a flame has been detected, a sophisticated computer program analyzes the fluctuations in its near-infrared intensity -- its so-called infrared signature -- and determines whether to sound an alarm. While infrared signature analysis has been used by the military in a variety of ways, using it for fire detection is a new application.

"We have 'taught' the detector not to respond to common household flames such as candles, gas stoves and cigarette lighters," Sivathanu says. "It also does not respond to fluctuations from hot plates, solar radiation or fluorescent light, which are different than those from uncontrolled flame.

"We also installed a corrective filter when we learned that the detector went off when someone waved their hand quickly in front of a hot plate placed in direct view of the detector. We still have a problem with the alarm going off from a fireplace, which is an uncontrolled flame, but we are developing ways that may make the device 'blind' to certain spots in the room. Conventional smoke detectors also go off from smoke from fireplaces."

Another bug to be worked out of the new detector is its difficulty in picking up smoldering fires, an area where smoke detectors also are slow to respond because of the time it takes for the smoke to reach the detector.

"The intensities obtained for smoldering fires are too low for our detector to successfully discriminate them from background noise," Gore says. "However, new, more sensitive infrared technologies are now available that might boost this capability in our detector."

Sivathanu and Gore have received a new, three-year grant from NIST for research that will focus on detecting the far-infrared radiation emitted from a fire, the type of radiation associated with smoldering.

Sources: Jay Gore, (765) 494-1452; e-mail, gore@ecn.purdue.edu
Yudaya Sivathanu, (765) 494-9364; e-mail, sivathan@ecn.purdue.edu
Writer: Amanda Siegfried, (765) 494-4709; e-mail, amanda_siegfried@uns.purdue.edu
Purdue News Service: (765) 494-2096; e-mail, purduenews@uns.purdue.edu

Purdue University

Related Radiation Articles from Brightsurf:

Sheer protection from electromagnetic radiation
A printable ink that is both conductive and transparent can also block radio waves.

What membrane can do in dealing with radiation
USTC recently found that polymethylmethacrylate (PMMA) and polyvinyl chloride (PVC) can release acidic substance under γ radiation, whose amount is proportional to the radiation intensity.

First measurements of radiation levels on the moon
In the current issue (25 September) of the prestigious journal Science Advances, Chinese and German scientists report for the first time on time-resolved measurements of the radiation on the moon.

New biomaterial could shield against harmful radiation
Northwestern University researchers have synthesized a new form of melanin enriched with selenium.

A new way to monitor cancer radiation therapy doses
More than half of all cancer patients undergo radiation therapy and the dose is critical.

Nimotuzumab-cisplatin-radiation versus cisplatin-radiation in HPV negative oropharyngeal cancer
Oncotarget Volume 11, Issue 4: In this study, locally advanced head and neck cancer patients undergoing definitive chemoradiation were randomly allocated to weekly cisplatin - radiation {CRT arm} or nimotuzumab -weekly cisplatin -radiation {NCRT arm}.

Breaking up amino acids with radiation
A new experimental and theoretical study published in EPJ D has shown how the ions formed when electrons collide with one amino acid, glutamine, differ according to the energy of the colliding electrons.

Radiation breaks connections in the brain
One of the potentially life-altering side effects that patients experience after cranial radiotherapy for brain cancer is cognitive impairment.

Fragmenting ions and radiation sensitizers
The anti-cancer drug 5-fluorouracil (5FU) acts as a radiosensitizer: it is rapidly taken up into the DNA of cancer cells, making the cells more sensitive to radiotherapy.

'Seeing the light' behind radiation therapy
Delivering just the right dose of radiation for cancer patients is a delicate balance in their treatment regime.

Read More: Radiation News and Radiation Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.