New way to write to magnetic chips

August 25, 1999


ITHACA, N.Y. -- Cornell University researchers have demonstrated a new way to write information to magnetic material that could lead to new computer memory chips that will have a very high storage capacity and will be non-volatile, meaning they would not require a constant electric current flowing to maintain stored information.

Dan Ralph, Cornell assistant professor of physics, says the effect was demonstrated in devices between 10 nanometers and 100 nanometers across. If the effect can be commercially harnessed with 10-nanometer devices, he says, it will make possible single chips capable of storing terabits (billions of bits) of information. A nanometer is one-billionth of a meter, or about three times the diameter of an atom.

The researchers have shown that a small electric current passed through a "sandwich" of two layers of magnetic material separated by a copper conductor can controllably switch the orientation of the "magnetic moment" -- that is, flip the north and south poles -- of a small magnetized area. The experiment, which confirms theoretical predictions, is reported in the Aug. 6, 1999, issue of Science magazine.

Using the facilities of the Cornell Nanofabrication Facility, the researchers created two thin layers of cobalt separated by a copper spacer. The upper cobalt layer is less than 10 nanometers thick, the copper layer is 4 nanometers thick, and the lower cobalt layer is about 100 nanometers thick. A tiny copper electrode touches the top of the upper layer.

By passing an electrical current perpendicularly through the layers, the researchers were able to reverse the orientation of the magnetic moments in a region of the thinner cobalt layer, while leaving the thicker layer unchanged. The result was that the north and south poles in the two layers pointed in non-parallel directions. Reversing the current flipped the thin layer back so that the moments in the two layers were again parallel.

The orientation of the magnetization in the two layers can be read by simply passing a much weaker electric current through the two layers, because the resistance is much higher when the two moments are non-parallel. This means the effect could be used to create a computer memory chip in which each tiny magnetized area represents a "one" when the moments are parallel or a "zero" when they are opposed.

The effect works, the researchers said in their paper, because electrons passing through a magnetic material are "spin polarized," meaning that they are spinning in the same direction, with their axes lined up. When the electrons previously polarized by passing through the thick magnetic layer collide with the thin one, they apply a twisting force that can cause the magnetic moment in that layer to switch orientation. Electrons that pass through the thin layer first are reflected back off the thick layer, with reversed polarization, to have the same effect.

Such an effect was predicted by John Slonczewski, a theoretical physicist at the IBM research laboratory in Yorktown Heights, N.Y. Previously the only means by which the magnetic poles could be reoriented in magnetic devices was through the application of an external magnetic field.

The simple switching effect only occurs in films four nanometers thick or less, Ralph says. With thicker films, spin-polarized currents induce more complicated motions of the magnetic moments, yet to be studied in detail. The initial experiment was conducted in an apparatus cooled to 4.2 degrees above absolute zero by liquid helium. In later work, reported in a paper, "Current-Driven Magnetization Reversal and Spin Wave Excitations in Co/Cu/Co Pillars," submitted to Physical Review Letters the researchers demonstrated the same effect at room temperatures.

The Science paper is titled "Current-Induced Switching of Domains in Magnetic Multilayer Devices." The authors are Ralph, graduate student Edward Myers, former graduate student Richard Louie (now at Pacific Lutheran University, in Tacoma, Wash.), post-doctoral research associate Jordan Katine and Robert Buhrman, the J. E. Sweet Professor of Engineering.
-end-
Related World Wide Web sites: The following sites provide additional information on this news release.

Daniel Ralph's web page: http://www.lassp.corne ll.edu/lassp_data/ralph.html

The Cornell Laboratory of Atomic and Solid State Physics: http://www.lassp.cornell.edu/

Cornell University

Related Magnetic Material Articles from Brightsurf:

Topology gets magnetic: The new wave of topological magnetic materials
The electronic structure of nonmagnetic crystals can be classified by complete theories of band topology, reminiscent of a 'topological periodic table.' However, such a classification for magnetic materials has so far been elusive, and hence very few magnetic topological materials have been discovered to date.

Magnetic field with the edge!
This study overturns a dominant six-decade old notion that the giant magnetic field in a high intensity laser produced plasma evolves from the nanometre scale.

Spintronics: Researchers show how to make non-magnetic materials magnetic
A complex process can modify non-magnetic oxide materials in such a way to make them magnetic.

Manipulating non-magnetic atoms in a chromium halide enables tuning of magnetic properties
The magnetic properties of a chromium halide can be tuned by manipulating the non-magnetic atoms in the material, a team, led by Boston College researchers, reports in the most recent edition of ScienceAdvances.

Quantum exciton found in magnetic van der Waals material NiPS3
A new type of exciton in magnetic van der Waals material NiPS3 is intrinsically of many-body origin.This is an actual realization of a genuine quantum state of diverse possible use in f quantum information&computing.

Magnetic memory states go exponential
Researchers showed that relatively simple structures can support exponential number of magnetic states - much greater than previously thought - and demonstrated switching between the states by generating spin currents.

The magnetic history of ice
The history of our planet has been written, among other things, in the periodic reversal of its magnetic poles.

New material has highest electron mobility among known layered magnetic materials
A new material created in the lab at Princeton has properties that make it a promising candidate for new areas like magnetic twistronic devices and spintronics, as well as advances in data storage and device design.

Not everything is ferromagnetic in high magnetic fields
High magnetic fields have a potential to modify the microscopic arrangement of magnetic moments because they overcome interactions existing in zero field.

Tiny magnetic particles enable new material to bend, twist, and grab
A team of researchers from the Georgia Institute of Technology and The Ohio State University has developed a soft polymer material, called magnetic shape memory polymer, that uses magnetic fields to transform into a variety of shapes.

Read More: Magnetic Material News and Magnetic Material Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.