Building walls that will make summer heat waves more bearable

September 28, 2020

With the summer heat becoming increasingly unbearable and prolonged over the years due to climate change, the cooling load in the summertime has also been on the rise. Insulation is currently the primary solution for blocking heat from entering a building, but by applying an additional material that can delay heat penetration, it can suppress the indoor temperature from rising and in turn lower the cooling load of the building.

A research team in Korea has developed a new material for buildings walls that can help reduce the penetration of heat from the outside. The team directed by Dr. Sarng Woo Karng from the National Research Agenda Division of the Korea Institute of Science and Technology (KIST) revealed that they have successfully lowered heat penetration through building walls by applying a phase change material (PCM).

PCMs refer to materials that absorbs or releases heat from/to the surrounding area but does not change temperature during phase change. One of the most common types is paraffin oil, which is used to make candles. A solid PCM absorbs heat as it transitions into liquid phase, so by using a case to hold it when it is in liquid phase without causing any leakage, it is possible to apply them to a building wall to block heat from entering inside.

The problem is, however, PCMs do not melt evenly from the outside toward the inside during phase transition from solid to liquid. To be more specific, PCMs turn into liquid starting from the outermost layer, and the parts that are hot move upward, while the parts that are still relatively cool move downward. Thus, while the upper part may have completely melted, the lower part will have not, and as a result, heat will penetrate into the building through the area where the PCM is in liquid phase. Ultimately, the PCM becomes ineffective in controlling the indoor temperature and is rendered useless.

Dr. Karng's team addressed the non-uniform phase change with bubble injections. By injecting bubbles into bottom part of the PCM during phase transition enabled uniform circulation of the PCM in liquid phase. As a result, the PCM melted from the area closest to the envelope in a uniform manner, and heat penetration was inhibited across the building wall until the entire PCM melted.

Dr. Karng said, "We expect that the insulating wall using the PCM bubble generator used in this study will contribute to reducing the amount of energy used to heat or cool a building. Insulation techniques using PCMs helps reduce heat penetration, in combination with the building insulating material, and it can also be used as the outer walls of zero-energy buildings."
-end-
This study was carried out with a grant from the Ministry of Science and ICT (MSIT), as part of the Institutional R&D Program of KIST. It was published in the latest edition of Energy Conversion and Management (Top 1.87% in the field of JCR), a leading international journal in the energy sector.

National Research Council of Science & Technology

Related Phase Transition Articles from Brightsurf:

Winners and losers of energy transition
Drastically reducing greenhouse gas emissions in the electricity sector could have substantial economic and social impacts.

Improving the transition from pediatric to adult rheumatology care
As children with chronic rheumatic illnesses age, it's important that they experience a smooth transition from pediatric to adult care.

Energy transition away from coal in China will yield benefits
China is the world's largest producer and consumer of coal.

Is the Earth's transition zone deforming like the upper mantle?
In a recently published paper in Earth and Planetary Science Letters, researchers from the Geodynamics Research Center, Ehime University and the University of Lille combine numerical modeling of dislocation glide and results from diffusion experiments to revisit the rheology of wadsleyite, ringwoodite and majorite garnet under geological strain rates across the transition zone of the Earth's mantle based on theoretical plasticity modeling.

Renewable energy transition makes dollars and sense
New UNSW research has disproved the claim that the transition to renewable electricity systems will harm the global economy.

Navigating the clean energy transition during the COVID-19 crisis
In a Commentary published April 29 in the journal Joule, energy and climate policy researchers in Switzerland and Germany provide a framework for responsibly and meaningfully integrating policies supporting the clean energy transition into the COVID-19 response in the weeks, months, and years to come.

Physicists find evidence of previously unseen transition in ferroelectrics
Proposed a century ago, inverse transitions seem to contradict the fundamental law that disorder increases with temperature.

How fish fins evolved just before the transition to land
Research on fossilized fish details the evolution of fins as they began to transition into limbs fit for walking on land.

Chemists glimpse the fleeting 'transition state' of a reaction
Chemists at MIT, Argonne National Laboratory, and several other institutions have devised a technique that allows them to determine the structure of the transition state of a reaction by observing the products that result from the reaction.

Transition to exhaustion: clues for cancer immunotherapy
Emory research on immune cells 'exhausted' by chronic viral infection provides clues on how to refine cancer immunotherapy.

Read More: Phase Transition News and Phase Transition Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.