Improved redox flow batteries for electric cars

October 12, 2009

Electric mobility is becoming increasingly important. The German government's ambitious plan envisages one million electric cars being sold in Germany by the year 2020. Until then, however, researchers still have to overcome some hurdles, such as the question of energy storage. Lithium-ion batteries offer a possible solution, but it takes hours to charge them - time that an automobile driver doesn't have when on the road. Researchers from the Fraunhofer Institute for Chemical Technology ICT in Pfinztal near Karlsruhe see an alternative in redox flow batteries. "These batteries are based on fluid electrolytes. They can therefore be recharged at the gas station in a few minutes - the discharged electrolyte is simply pumped out and replaced with recharged fluid," says engineer Jens Noack from ICT. "The pumped-off electrolyte can be recharged at the gas station, for example, using a wind turbine or solar plant."

The principle of redox flow batteries is not new - two fluid electrolytes containing metal ions flow through porous graphite felt electrodes, separated by a membrane which allows protons to pass through it. During this exchange of charge a current flows over the electrodes, which can be used by a battery powered device.

Until now, however, redox flow batteries have had the disadvantage of storing significantly less energy than lithium-ion batteries. The vehicles would only be able to cover about a quarter of the normal distance - around 25 kilometers - which means the driver would have to recharge the batteries four times as often. "We can now increase the mileage four or fivefold, to approximately that of lithium-ion batteries," Noack enthuses. The researchers have already produced the prototype of a cell. Now they must assemble several cells into a battery and optimize them. This further development is being carried out with colleagues from the University of Applied Sciences, Ostphalia, in Wolfenbüttel and Braunschweig. They are testing electric drives and energy storage units on model vehicles that are only a tenth of the size of normal vehicles. The research team has already built a traditional redox flow battery into a model vehicle. A vehicle on a scale of 1:5 can be seen in action on a test rig set up at the eCarTech in Munich (Hall C3, Stand 424) from 13 to 15 October. In the coming year the researchers also want to integrate the new battery, with four times greater mileage, into a model vehicle.
-end-


Fraunhofer-Gesellschaft

Related Energy Storage Articles from Brightsurf:

Reviewing multiferroics for future, low-energy data storage
Big data and exponential demands for computations are driving an unsustainable rise in global ICT energy use.

The perfect angle for e-skin energy storage
Researchers at DGIST have found an inexpensive way to fabricate tiny energy storage devices that can effectively power flexible and wearable skin sensors along with other electronic devices, paving the way towards remote medical monitoring & diagnoses and wearable devices.

Upcycling plastic waste toward sustainable energy storage
UC Riverside engineering professors Mihri and Cengiz Ozkan and their students have been working for years on creating improved energy storage materials from sustainable sources, such as glass bottles, beach sand, Silly Putty, and portabella mushrooms.

Chemists advance solar energy storage aimed at global challenges
Multi-university effort develops solar energy storage to enable decentralized electrification systems in remote areas.

Energy-saving servers: Data storage 2.0
A research team of Mainz University has developed a technique that will potentially halve the energy required to write data to servers and make it easier to construct complex server architectures.

Energy storage using oxygen to boost battery performance
Researchers have presented a novel electrode material for advanced energy storage device that is directly charged with oxygen from the air.

New material, modeling methods promise advances in energy storage
The explosion of mobile electronic devices, electric vehicles, drones and other technologies have driven demand for new lightweight materials that can provide the power to operate them.

Finding balance between green energy storage, harvesting
Generating power through wind or solar energy is dependent on the abundance of the right weather conditions, making finding the optimal strategy for storage crucial to the future of sustainable energy usage.

Diamonds shine in energy storage solution
QUT researchers have proposed the design of a new carbon nanostructure made from diamond nanothreads that could one day be used for mechanical energy storage, wearable technologies, and biomedical applications.

Gas storage method could help next-generation clean energy vehicles
A Northwestern University research team has designed and synthesized new materials with ultrahigh porosity and surface area for the storage of hydrogen and methane for fuel cell-powered vehicles.

Read More: Energy Storage News and Energy Storage Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.