Electrical conductivity of single-molecule 'wires' accurately measured

October 18, 2001

Molecular-scale electronics has been widely touted as "the next step" in electronic miniaturization, with theory and research suggesting that single molecules may have the capability to take the place of today's much larger electronic components. A critical problem, however, has been in manipulating single molecules so that their electronic capabilities can be tested and then applied.

"Progress in the field has been hampered by two problems," said Arizona State University Chemistry Professor Devens Gust. "The first has been in making robust, reproducible electrical connections to both ends of molecules. After this has been achieved, the next problem is knowing how many molecules there actually are between the electrical contacts."

"The results of studying the conductivity of molecules attached to wires have been all over the map," said ASU Professor of Physics Stuart Lindsay. "For example, according to published articles, DNA has been found to be everything from an insulator to a superconductor. The problem has been that no one has been able to reliably connect a single molecule. "

Past attempts to measure the electrical properties of small numbers of molecules have given a wide range of values for their conductivities. Most previous studies have relied on a "mechanical" contact between molecules and a metallic wire, where the two are simply pushed together.

"Any hobbyist knows that the best electrical contacts are made by soldering the components together," Gust said. "What we've needed is a way to 'solder' individual molecules on a molecular 'circuit board,'". This has now been done by a multidisciplinary team that includes Gust, Lindsay, ASU physicists Xiadong Cui, John Tomfohr, and Otto Sankey, ASU chemists Alex Primak, Xristo Zarate, Ana Moore, and Thomas Moore, and Motorola, Inc. scientist Gari Harris. In a paper forthcoming in the October 19 issue of the journal Science, the team reports a method for creating through-bond electrical contacts with single molecules and the achievement of reproducible measurements of the molecules' conductivity.

The researchers began with a uniform atomic layer of gold atoms, and attached long, octanethiol 'insulator' molecules to it through chemical bonds, forming a fur-like coating of aligned molecules. They removed a few of the insulators using a solvent and replaced them with molecules of 1,8-octanedithiol, a molecule that is similar, but is capable of bonding with gold at both ends and acting as a molecular "wire".

Tiny (two nanometer) gold particles were then added to the solvent, where they bonded to the free ends of the 1,8-octanedithiol molecules, thus creating a bonded metallic "contact" at either end of the conducting molecules. A gold-coated conducting atomic force microscope probe -- a conducting probe with an atom-sized tip - was then run across the surface and conductivity was measured when it made contact with the gold particles.

When electrical measurements were made on over 4,000 gold particles, virtually all measurements fell into one of five groups (five distinct conductivity curves). The conductivity curves were distinct whole number multiples of a single, 'fundamental' curve.

"This answers the basic question of how you know when you are measuring just one molecule," said Gust. The fundamental curve represents conduction by a single molecule of octanedithiol attached to the two gold contacts. When more than a single molecule was bound, each additional molecule increased the current capacity by the single unit amount of current that could be carried by one molecule. When the probe encountered octanethiol "insulator" molecules, which could not bond with a gold particle, a much higher electrical resistance was recorded.

"The experimental results closely agree with theoretical quantum mechanical calculations for the conductivity of these molecules, and this gives us confidence that current theories can provide useful guidance for future experiments," Gust noted.

"The molecule becomes a much better conductor when it is 'soldered' into the circuit by the bonds to gold at each end," Gust said. "This suggests how we can wire single molecule components into a molecular circuit board, and lays some important groundwork for doing practical molecular electronics."
-end-
Sources: Devens Gust 480-965-4430
Stuart Lindsay 480-965-4691

Arizona State University

Related Molecules Articles from Brightsurf:

Finally, a way to see molecules 'wobble'
Researchers at the University of Rochester and the Fresnel Institute in France have found a way to visualize those molecules in even greater detail, showing their position and orientation in 3D, and even how they wobble and oscillate.

Water molecules are gold for nanocatalysis
Nanocatalysts made of gold nanoparticles dispersed on metal oxides are very promising for the industrial, selective oxidation of compounds, including alcohols, into valuable chemicals.

Water molecules dance in three
An international team of scientists has been able to shed new light on the properties of water at the molecular level.

How molecules self-assemble into superstructures
Most technical functional units are built bit by bit according to a well-designed construction plan.

Breaking down stubborn molecules
Seawater is more than just saltwater. The ocean is a veritable soup of chemicals.

Shaping the rings of molecules
Canadian chemists discover a natural process to control the shape of 'macrocycles,' molecules of large rings of atoms, for use in pharmaceuticals and electronics.

The mysterious movement of water molecules
Water is all around us and essential for life. Nevertheless, research into its behaviour at the atomic level -- above all how it interacts with surfaces -- is thin on the ground.

Spectroscopy: A fine sense for molecules
Scientists at the Laboratory for Attosecond Physics have developed a unique laser technology for the analysis of the molecular composition of biological samples.

Looking at the good vibes of molecules
Label-free dynamic detection of biomolecules is a major challenge in live-cell microscopy.

Colliding molecules and antiparticles
A study by Marcos Barp and Felipe Arretche from Brazil published in EPJ D shows a model of the interaction between positrons and simple molecules that is in good agreement with experimental results.

Read More: Molecules News and Molecules Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.