Guarding giants with tiny protectors

October 21, 2005

How do you build an infrared (IR) camera that is small enough to fit on a mini-unmanned aerial vehicle (UAV) without cryogenic cooling? Call in the nanobots.

Researchers working with the Office of Naval Research (ONR) have developed a way to build extremely small sensors using nanorobot fabrication. This new process, created by Harold Szu and James Buss of ONR and implemented by Xi Ning of Michigan State University, allows a human operator using a powerful microscope and hand-held controller to manipulate nano-sized contact points remotely--like using extremely small hands--to construct the pixel elements that will form the heart of the sensor. Each pixel will be composed of carbon nanotubes, which have nanoscale diameters and submicron lengths. Because of the one-dimensional nature of carbon nanotubes, they have significantly lower thermal noise than traditional semi-conductors. A full-sized camera incorporating this technology would be inexpensive and lightweight--about one tenth the cost, weight, and size of a conventional digital camera.

The reason for making such a small sensor has to do with the largest of things--protecting multibillion-dollar aircraft carriers and their thousands of Sailors. Today, missiles have gotten smaller, stealthier, and more difficult to detect than ever--and you don't need to have the budget of a superpower (or even be a power at all) to buy or manufacture them. To improve the ability of carrier strike groups to detect these missiles over the horizon, the U.S. Navy is searching for ways to augment its surveillance capabilities with a covert team of mini-UAVs equipped with passive sensors that can cruise near the ocean surface at slow speeds for many hours.

One of the salient features distinguishing a missile plume from flare camouflage is the unique characteristics of a plume's IR signature, especially in the mid-IR spectrum. The signal-to-noise ratio of a conventional IR detector array operating in the ocean environment, however, demands the use of cumbersome liquid nitrogen cryogenic cooling for all current mid-IR spectrum cameras. Unfortunately, a mini-UAV's payload limitation does not allow such a bulky technology on board--but a small UAV is possible with the advent of nano-based sensors.

The proposed IR camera is being considered for other applications as well, including the field of breast cancer detection. "This new technology will revolutionize how sensors, cameras, and countless other medical devices will be made by a nanorobot, which can respond to public demands of non-contact examinations for early cancer screening at every household," said Father Giofranco Basti of the Pontifical Lateran University at the Vatican City, Rome, Italy. Next spring, the university will conduct a screening test bed of early breast tumor treatment using this new technology in collaboration with ONR.
-end-


Office of Naval Research

Related Carbon Nanotubes Articles from Brightsurf:

How plantains and carbon nanotubes can improve cars
Researchers from the University of Johannesburg have shown that plantain, a starchy type of banana, is a promising renewable source for an emerging type of lighter, rust-free composite materials for the automotive industry.

New production method for carbon nanotubes gets green light
A new method of producing carbon nanotubes -- tiny molecules with incredible physical properties used in touchscreen displays, 5G networks and flexible electronics -- has been given the green light by researchers, meaning work in this crucial field can continue.

Growing carbon nanotubes with the right twist
Researchers synthetize nanotubes with a specific structure expanding previous theories on carbon nanotube growth.

Research shows old newspapers can be used to grow carbon nanotubes
New research has found that old newspaper provide a cheap and green solution for the bulk production of single walled carbon nanotubes.

Clean carbon nanotubes with superb properties
Scientists at Aalto University, Finland, and Nagoya University, Japan, have found a new way to make ultra-clean carbon nanotube transistors with superior semiconducting properties.

Dietary fiber effectively purifies carbon nanotubes
A dietary fiber can help separate out semiconducting carbon nanotubes used for making transistors for flexible electronics.

Why modified carbon nanotubes can help the reproducibility problem
Scientists at Tokyo Institute of Technology (Tokyo Tech) conducted an in-depth study on how carbon nanotubes with oxygen-containing groups can be used to greatly enhance the performance of perovskite solar cells.

Tensile strength of carbon nanotubes depends on their chiral structures
Single-walled carbon nanotubes should theoretically be extremely strong, but it remains unclear why their experimental tensile strengths are lower and vary among nanotubes.

New study reveals carbon nanotubes measurement possible for the first time
Swansea University scientists report an entirely new approach to manipulation of carbon nanotubes that allows physical measurements to be made on carbon nanotubes that have previously only been possible by theoretical computation.

Neural networks will help manufacture carbon nanotubes
A team of scientists from Skoltech's Laboratory of Nanomaterials proposed a neural-network-based method for monitoring the growth of carbon nanotubes, preparing the ground for a new generation of sophisticated electronic devices.

Read More: Carbon Nanotubes News and Carbon Nanotubes Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.