Future cars to have more power, thanks to MIT work

October 29, 2000

An MIT solution for punching up the electrical power in future cars turns out to be inexpensive to implement and, as a welcome side effect, will also significantly increase a vehicle's fuel economy.

"On average we get twice as much power from the new technology," said David J. Perreault, the research scientist in MIT's Laboratory for Electromagnetic and Electronic Systems who led the work. And because the technology "builds on elements that already exist in a car," it can be integrated fairly easily - and cheaply - into the existing manufacturing process.

One of the key challenges associated with building the car of the future is increasing the amount of electrical power available to the vehicle. Nifty features like heated windshields, new devices for cutting noxious emissions, and advanced suspensions will require more power than the current 14-volt automobile electrical system can handle. In addition, "higher power will allow many existing features to work better," said Dr. Perreault, who presented a paper on the work October 17 at the Convergence 2000 conference in Detroit.

Hence the push to move from 14 to 42 volts. "It doesn't sound like it would be that difficult to do," Dr. Perreault said, "but it turns out that there are several subtle technical problems." The MIT/Industry Consortium on Advanced Automotive Electrical/Electronic Components and Systems, which supports Dr. Perreault's work, "was tasked with finding solutions to these problems."

TOWARD MORE POWER
The work focuses on the alternator, or electrical generator, of a car. Dr. Perreault and Vahe Caliskan (MIT PhD 2000) tackled the problem by first modeling it mathematically. "We tried to boil it down to the simplest thing you could do to achieve the desired goal," Dr. Perreault said. They then built a revised alternator based on their mathematical models.

"Essentially we replaced three of the passive elements for directing current--diodes--with three active switches," Dr. Perreault said. "That gives us more ways to control the current flowing through the system." As a result, "I can use those switches to optimize current flow to get higher power."

He explained that conventional alternators are designed to optimize current flow only at idle. "At every other speed they're very suboptimal." The new technology optimizes current flow at these other operating points resulting in higher output power and also higher efficiency.

WELCOME SIDE EFFECTS
Because the new system is more efficient, "It also dissipates less energy as heat," Dr. Perreault said. "And that means the car burns considerably less gas to get the same amount of power."

The increased control over current flow also solves another major problem associated with a higher-voltage system: large unexpected jumps in voltage due to changes in current. Dr. Perreault explained that in a 14 volt system, the voltage can jump to an undesirable 80 volts when the system is disturbed in certain ways - for example, if the battery connector is jiggled during operation. As a result, "everything is designed to survive at 80 volts."

In the same situation, however, a 42 volt system could spike to 240 volts. Among other drawbacks, that would mean that the car would have to be redesigned to survive the higher jolt. And that, of course, would be expensive.

The new technology solves this problem by also allowing much greater control of the voltage. As a result, said Dr. Perreault, "our base voltage of 42 volts can be limited to about 60 volts during such an episode."

The technology also solves yet another problem: jumpstarting a 42 volt vehicle with a 14 volt car. "People want to come out with 42 volt vehicles, but the passenger cars on the road all have 14 volt batteries," said Dr. Perreault. "If a car has a 42 volt battery it cannot be directly jump-started from a 14-volt car. In fact, unpleasant things-like explosions - could happen."

Any alternator, however, stores energy magnetically when it carries current. "Typically this actually hinders performance," Dr. Perreault said. "We're using it here to help us."

The energy storage ability of the alternator coupled with the increased controls of the new system "allow you to take energy from a 14 volt battery and pump it up to the 42 volt battery you're trying to charge," Dr. Perreault said.

The reaction to the work from members of the consortium that funded it "has been very strong and very positive," Dr. Perreault reports. As a result, he said, "I'm very pleased."
-end-
MEET THE SCIENTIST
Dave Perreault has always liked electronics, perhaps because his father is a professor of electrical and computer engineering at Boston University. "So when I came to MIT as a graduate student (MIT SM 1991, MIT PhD1997), I went into what I enjoyed."

Once of his present interests is automotive electronics, said the driver of a black Volvo 850 wagon, "because that's a place where there's lots of room to make a big impact."

The goal of the work described in the accompanying story was to increase the electrical power available to cars. Other advantages of the resulting technology - like increased fuel efficiency - weren't obvious at first. "As we worked on the problem, we realized we could do more and more with it," he said. "We attacked it piece by piece. It's been fun!"

Dr. Perreault and his wife Hideko, son Daniel, and two gigantic dogs live in Brookline, Mass.

Massachusetts Institute of Technology

Related Technology Articles from Brightsurf:

December issue SLAS Technology features 'advances in technology to address COVID-19'
The December issue of SLAS Technology is a special collection featuring the cover article, ''Advances in Technology to Address COVID-19'' by editors Edward Kai-Hua Chow, Ph.D., (National University of Singapore), Pak Kin Wong, Ph.D., (The Pennsylvania State University, PA, USA) and Xianting Ding, Ph.D., (Shanghai Jiao Tong University, Shanghai, China).

October issue SLAS Technology now available
The October issue of SLAS Technology features the cover article, 'Role of Digital Microfl-uidics in Enabling Access to Laboratory Automation and Making Biology Programmable' by Varun B.

Robot technology for everyone or only for the average person?
Robot technology is being used more and more in health rehabilitation and in working life.

Novel biomarker technology for cancer diagnostics
A new way of identifying cancer biomarkers has been developed by researchers at Lund University in Sweden.

Technology innovation for neurology
TU Graz researcher Francesco Greco has developed ultra-light tattoo electrodes that are hardly noticeable on the skin and make long-term measurements of brain activity cheaper and easier.

April's SLAS Technology is now available
April's Edition of SLAS Technology Features Cover Article, 'CURATE.AI: Optimizing Personalized Medicine with Artificial Intelligence'.

Technology in higher education: learning with it instead of from it
Technology has shifted the way that professors teach students in higher education.

Post-lithium technology
Next-generation batteries will probably see the replacement of lithium ions by more abundant and environmentally benign alkali metal or multivalent ions.

Rethinking the role of technology in the classroom
Introducing tablets and laptops to the classroom has certain educational virtues, according to Annahita Ball, an assistant professor in the University at Buffalo School of Social Work, but her research suggests that tech has its limitations as well.

The science and technology of FAST
The Five hundred-meter Aperture Spherical radio Telescope (FAST), located in a radio quiet zone, with the targets (e.g., radio pulsars and neutron stars, galactic and extragalactic 21-cm HI emission).

Read More: Technology News and Technology Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.