Voltage-driven liquid metal fractals

October 30, 2017

Researchers from North Carolina State University have found that gallium indium (EGaIn), a liquid metal with one of the highest surface tensions, can be induced to spread and form patterns called fractals with the application of low voltage. The work has implications for controlling the shape of liquid metals.

Surface tension is the force exerted by the surface of a liquid that causes it to "bead up" or form droplets. Water, for example, has a high surface tension, so it beads up, whereas alcohol, with a lower surface tension, tends to spread out. Liquid metals, such as mercury, have enormous surface tension and thus are almost always spherical. In fact, EGaIn has the highest surface tension of any known liquid at room temperature.

In a surprising finding, NC State professor of physics Karen Daniels and professor of chemical and biomolecular engineering Michael Dickey discovered that applying low voltage to the surface of EGaIn causes the liquid metal to spread out and form snowflake-like fractal patterns.

"Applying voltage to EGaIn forms a thin layer of oxide on the surface of the metal, which effectively lowers the surface tension," Dickey says. "Normally, the tension of liquids can be lowered by adding surfactants - like putting soap or detergent in water - to the liquid. It's easy to put soap into water, but hard to get the soap out. In contrast, the use of voltage to control the tension is interesting because it is reversible, and incredibly effective."

"We also found that if you apply higher amounts of voltage to the metal it stops spreading and beads up again," Daniels says. "That's due to the amount of oxide produced - a small amount lowers the surface tension, but too much forms a crust over the metal and stops it spreading. So controlling the voltage is a nice way to control the spreading of the metal."

The researchers recorded the metal's behavior as the surface tension lowered. Less than one volt of electricity caused the metal to spread out and form different fractals, or patterns. Interestingly, the fractals formed by the EGaIn appear to be unique; that is, they do not match any currently described fractals. "Aside from being unusual, the other implication of these fractals is that in order for them to form the surface tension of the liquid metal must be close to zero," Daniels says.

"This work suggests that not only does the formation of the oxide lower the surface tension of the liquid metal, but that it also creates compressive stresses - the opposite of tension - that help the metal spread out and form fractals," Dickey says. "This is interesting because liquids are always under tension, and we now have a tool to apply compressive forces directly to the surface of a liquid. These properties give us greater control over the metal's behavior."
-end-
The work appears in Physical Review Letters, and is funded by the National Science Foundation (grants DMR-1608097 and CMMI-0954321) and the Air Force Research Lab. Daniels is corresponding author. Graduate student Collin Eaker and undergraduate students David Hight and John O'Reagan contributed to the work.

Note to editors: An abstract of the paper follows.

"Oxidation-Mediated Fingering in Liquid Metals"

DOI: 10.1103/PhysRevLett.119.174502

Authors: Collin Eaker, David Hight, John O'Reagan, Michael Dickey and Karen Daniels, North Carolina State University

Published: Physical Review Letters

Abstract:

We identify and characterize a new class of fingering instabilities in liquid metals; these instabilities are unexpected due to the large interfacial tension of metals. Electrochemical oxidation lowers the effective interfacial tension of a gallium-based liquid metal alloy to values approaching zero, thereby inducing drastic shape changes, including the formation of fractals. The measured fractal dimension (D = 1:3_0:05) places the instability in a different universality class than other fingering instabilities. By characterizing changes in morphology and dynamics as a function of droplet volume and applied electric potential, we identify the three main forces involved in this process: interfacial tension, gravity, and oxidative stress. Importantly, we find that electrochemical oxidation can generate compressive interfacial forces that oppose the tensile forces at a liquid interface. Thus, the surface oxide layer not only induces instabilities, but ultimately provides a physical and electrochemical barrier that halts the instabilities at larger positive potentials. Controlling the competition between interfacial tension and oxidative (compressive) stresses at the interface is important for the development of reconfigurable electronic, electromagnetic, and optical devices that take advantage of the metallic properties of liquid metals.

North Carolina State University

Related Surface Tension Articles from Brightsurf:

Growing interest in Moon resources could cause tension, scientists find
An international team of scientists led by the Center for Astrophysics | Harvard & Smithsonian, has identified a problem with the growing interest in extractable resources on the moon: there aren't enough of them to go around.

How cells use mechanical tension sensors to interact with their environment
In a painstaking experiment, scientists suspended a single protein filament between two microscopic beads.

What tiny surfing robots teach us about surface tension
Propelled by chemical changes in surface tension, microrobots surfing across fluid interfaces lead researchers to new ideas.

A novel salvinia-like slippery surface
Inspired by the hydrophobic leaves of Salvinia molesta and the slippery Nepenthes pitcher plants, a Salvinia-like slippery surface (SSS) consisting of protrusions with slippery heads was designed.

Surface tension, not gravity, drives viscous bubble collapse
By demonstrating that surface tension -- not gravity -- drives the collapse of surface bubbles in viscous liquids, a new study flips the previous understanding of how viscous bubbles pop on its head.

Tadpoles break the tension with bubble-sucking
When it comes to the smallest of creatures, the hydrogen bonds that hold water molecules together to form 'surface tension' lend enough strength to support their mass: think of insects that skip across the surface of water.

Finding connections at the surface
How and where receptors touch at the surface of a cell may influence the strength of neuronal connections and contribute to identifying better medical interventions for pain, cancer other diseases.

Scratching the surface of perovskites
Professor Yabing Qi and his team in the Energy Materials and Surface Sciences Unit at OIST, in collaboration with researchers at the University of Pittsburgh, USA, have, for the first time, characterized the structural defects that prompt the movement of ions, destabilizing the perovskite materials.

What makes the Earth's surface move?
Do tectonic plates move because of motion in the Earth's mantle, or is the mantle driven by the plates' movement?

Tension around autonomy increases family conflict at end of life
Conflict within families can be stressful and confusing, and it can lead to feelings of sadness.

Read More: Surface Tension News and Surface Tension Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.