Water-energy nanogrid provides solution for rural communities lacking basic amenities

November 04, 2020

Researchers at Texas A&M University have come up with an economical, green solution that can help underprivileged communities with their water and electricity needs.

Their standalone water-energy nanogrid consists of a purification system that uses solar energy to decontaminate water. The setup, they said, is mathematically tuned to use solar energy optimally so that the water filtration is unhindered by the fluctuations of solar energy during the course of the day.

"To serve areas that are remote and isolated, the infrastructural cost of laying down new water pipes or setting up an electricity grid is enormous and can take a very long time," said Le Xie, professor in the Department of Electrical and Computer Engineering. "To overcome these hurdles, we presented a cost-effective solution that uses solar energy to both purify water and generate electricity for basic household use."

The researchers have described their technology in the journal .

In the United States, the colonias represent one of the many rural, low-income communities along the Texas-Mexico border where basic resources are not readily available. Since the colonias are remote, their residents, consisting of mainly migrant workers, are isolated from major utility and water treatment facilities and thus have limited means for electricity and safe drinking water. Methods like boiling water can be cost-prohibitive and inadequate.

"Boiling water is one of the most expensive ways of decontamination because it takes a lot of energy to heat water," said Shankar Chellam, professor in the Zachry Department of Civil and Environmental Engineering. "Also, although boiling gets rid of biological contaminants, it does not remove many chemical contaminants. We needed a solution that could address both these problems at the same time."

An efficient way to decontaminate water is by passing it through purification systems. These machines use pumps to push water through a filter. However, the pumps require electricity, which is again scarce in the colonias. So, the researchers looked for a solution that would help with both the power and water requirements of the colonia residents.

First, to cut the dependence on centralized sources of power and water, Xie, Chellam and their team conceptualized an energy-water nanogrid, which is a standalone, truck-mountable filtration system with pumps that could run on solar-generated electricity. Next, they developed a cost-minimization mathematical scheme, called scenario-based optimization framework, that minimized the total expenditure for the standalone setup by selecting the type of filter, the number and size of solar panels and the size of the solar battery.

This model revealed that if nanofiltration, a type of purification technique, was used, harvesting solar energy just during peak availability was sufficient to run pumps and purify water. In other words, the water nanofiltration system was largely unaffected by the day-to-day vagaries in solar energy and could purify enough water to meet the weekly water needs of the community. In this way, any excess solar power that was not used for filtration could be stashed away either for storage in the battery pack or for other minor basic household needs, like charging cell phone batteries.

The researchers noted that although the nanofiltration system is more sophisticated and expensive than other filtration methods, its overall merit is that it can successfully desalinate and remove chemicals, like arsenic, present in local groundwater. They said nanofiltration is a preferable method for desalination and water purification for other remote regions where the contaminants within the water are not already known.

"We have for the first time used a very rigorous mathematical approach to interlink water purification and energy provision," Chellam said. "This lays out a quantitative framework that can be used in not just the colonias but in any scenario based on local conditions."
-end-
Other contributors to the research include M. Sadegh Modarresi from Burns & McDonnell in Houston, Bilal Abada from the civil and environmental engineering department and S. Sivaranjani from the electrical and computer engineering department.

This work was supported in part by the Texas A&M Engineering Experiment Station, the Texas A&M Energy Institute and the National Science Foundation.

Texas A&M University

Related Solar Energy Articles from Brightsurf:

'Transparent solar cells' can take us towards a new era of personalized energy
Solar power has shown immense potential as a futuristic, 'clean' source of energy.

CU Denver researcher analyzes the use of solar energy at US airports
By studying 488 public airports in the United States, University of Colorado Denver School of Public Affairs researcher Serena Kim, PhD, found that 20% of them have adopted solar photovoltaic (PV), commonly known as solar panels, over the last decade.

Researchers develop molecule to store solar energy
Researchers at Linköping University, Sweden, have developed a molecule that absorbs energy from sunlight and stores it in chemical bonds.

Converting solar energy to hydrogen fuel, with help from photosynthesis
Global economic growth comes with increasing demand for energy, but stepping up energy production can be challenging.

New nanodevice could use solar energy to produce hydrogen
Amsterdam, June 9, 2020 - Solar energy is considered by some to be the ultimate solution to address the current energy crisis and global warming and the environmental crises brought about by excessive consumption of fossil fuels.

Physicists develop approach to increase performance of solar energy
Experimental condensed matter physicists in the Department of Physics at the University of Oklahoma have developed an approach to circumvent a major loss process that currently limits the efficiency of commercial solar cells.

Lasers etch a 'perfect' solar energy absorber
In Light: Science and Applications, University of Rochester researchers demonstrate how laser etching of metallic surfaces creates the ''perfect solar energy absorber.'' This not only enhances energy absorption from sunlight, but also reduces heat dissipation at other wavelengths.

Mapping the energy transport mechanism of chalcogenide perovskite for solar energy use
Researchers from Lehigh University have, for the first time, revealed first-hand knowledge about the fundamental energy carrier properties of chalcogenide perovskite CaZrSe3, important for potential solar energy use.

New hybrid device can both capture and store solar energy
Researchers have reported a new device that can both efficiently capture solar energy and store it until it is needed, offering promise for applications ranging from power generation to distillation and desalination.

Materials that can revolutionize how light is harnessed for solar energy
Columbia scientists designed organic molecules capable of generating two excitons per photon of light, a process called singlet fission.

Read More: Solar Energy News and Solar Energy Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.