Factors in the fabrication of heterojunctions of 2D-materials through CVD

November 10, 2017

2D-materials have special lattice structures. Atoms in the same layer were usually bound by the covalent bond, while the force between layers is van der Waals coupling. They have super clean surfaces without any dangling bonds. Thus, the design of heterojunctions will be flexible when 2D-materials are utilized to constitute heterojunctions. The heterojunctions formed by different 2D-materials have advantageous properties compared with their corresponding single-component 2D-material, such as optimizing band alignment, bandgap, charge transfer and optical properties. The research of heterojunctions is a hot topic in 2D-material field.

Recently, a review "Chemical vapor deposition growth of two-dimensional heterojunctions" by Prof. Zhongming Wei at Institute of Semiconductors, Chinese Academy of Sciences, is published in SCIENCE CHINA Physics, Mechanics & Astronomy. In this review, the methods of chemical vapor deposition (CVD) to fabricate 2D heterojunctions are referred based on researches in the last few years. Firstly, the development history of heterojunctions of 2D-materials is introduced. And then, the influences of different growth conditions on heterojunctions are discussed. Finally, some other methods to prepare heterojunctions are referred.

The transfer method is a convenience good technique for heterojunctions of 2D-materials in labs. Researchers can easily utilize this method to obtain the specific heterojunction they want. But it is not enough for the extensive applications, an efficient and stable technique is necessary. The chemical vapor deposition is introduced to fabricate heterojunctions as a potential method. The chemical vapor deposition method is sensitive to the changes of growth conditions. It is an important research topic to ascertain influences of different factors on the growth process and final heterojunctions. This review classifies the factors into temperature, substrate, precursor, lattice mismatch, carrier gas flow rate, and carrier gas composition. When anyone of factors is changed, the obtained heterojunctions will have different structures or components. These factors also influence each other. So, the desired heterojunctions of 2D-materials can't be fabricated by just modifying one parameter of the chemical vapor deposition system. For example, when different precursors are used, the growth temperature should be reset due to the different evaporating temperatures of different precursors. Besides these, the method through sulfuring patterned films, such as metal films, oxide films and other component films, to fabricate heterojunctions is also referred.

The further researches are necessary to solve problems in the fabrication of heterojunctions of 2D-materials. MBE and MOCVD can also be considered as good options of the fabrication technique.
This work was supported by the National Natural Science Foundation of China (Grant Nos. 61622406, 11674310, 61571415, and 51502283), the National Key Research and Development Program of China (Grant Nos. 2017YFA0207500, and 2016YFB0700700), "Hundred Talents Program" of Chinese Academy of Sciences (CAS), and the CAS/SAFEA International Partnership Program for Creative Research Teams.

See the article:

Yu Cui, Bo Li, Jingbo Li, and Zhongming Wei, Chemical vapor deposition growth of two-dimensional heterojunctions, SCIENCE CHINA Physics, Mechanics & Astronomy, 2018, vol. 61, No.1, 016801 http://engine.scichina.com/publisher/scp/journal/SCPMA/doi/10.1007/s11433-017-9105-x?slug=abstracthttps://link.springer.com/article/10.1007/s11433-017-9105-x

Science China Press
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.