Laser analyses fuel flame

November 15, 2002

In a project from the Technology Foundation STW, researcher Roger Evertsen has introduced a new method for measuring the composition of fuel flames. The technique makes use of laser light and is not only quick but also extremely sensitive.

During the combustion of fossil fuels such as natural gas and oil, combustion gases are released. These are mostly hydrogen and carbon dioxide. During the combustion process various partially converted fuel molecules are found in the flame. The chemical formulae of some of these molecules are OH, CH, HCO, CH2, NO and NO2. However, where and in what quantities these substances occur in the combustion chain is not completely clear. To gain more insight into this, Roger Evertsen carried out measurements in the flames of combusting natural gas.

The measurements were carried out using a technique which makes use of laser light that is directed through the flame. Mirrors are present on both sides of the flame so that the light is almost continually reflected through it. During each passage the glowing combustion products absorb a bit of the laser light and as a result of this the clarity of the laser gradually decreases. If the flame contains a high concentration of an absorbent material such as OH, the intensity of the laser light rapidly decreases. If the concentration of the intermediate product is small, as is the case for CH and CH2, less laser light will be absorbed. The level of this absorption as well as the rate at which it occurs is a measure of the quantity of combustion gas in the flame. Each substance is sensitive to a certain wavelength (colour) of the laser light and therefore a different laser is used for each substance.

Evertsen discovered that this cavity ring-down spectroscopy could measure HCO concentrations of 430 parts per million and CH2 concentrations of 80 parts per million. The toxic gases NO and NO2, which are difficult to measure using other techniques, could be detected at concentrations of 25 parts per million and 3 parts per million respectively. CH molecules could be detected at concentrations of just a few parts per billion.

The measurements were performed at both low and normal air pressure. At normal air pressure the area in which all chemical reactions occur is often no thicker than a millimetre. Measurements at low air pressure are therefore much more convenient because the flames are then much larger (the size of the flame is inversely proportional to the pressure). The experiments were carried out at normal pressure so as to model the real situation in a gas water heater or gas cooker.
-end-
Further information can be obtained from Dr Rogier Evertsen (Department of Applied Physics, University of Nijmegen), tel. +31 (0)24 3430725, fax +31 (0)24 3653311, e-mail rogier.evertsen@sci.kun.nl. The doctoral thesis was defended on 12 November 2002. Dr Evertsen's supervisors were Prof. Hans ter Meulen (University of Nijmegen) and Prof. Philip de Goey (Technical University Eindhoven).

The research was funded by the Netherlands Organisation for Scientific Research (NWO).

Netherlands Organization for Scientific Research

Related Laser Articles from Brightsurf:

Laser technology: New trick for infrared laser pulses
For a long time, scientists have been looking for simple methods to produce infrared laser pulses.

Sensors get a laser shape up
Laser writing breathes life into high-performance sensing platforms.

Laser-powered nanomotors chart their own course
The University of Tokyo introduced a system of gold nanorods that acts like a tiny light-driven motor, with its direction of motion is determined by the orientation of the motors.

What laser color do you like?
Researchers at the National Institute of Standards and Technology (NIST) and the University of Maryland have developed a microchip technology that can convert invisible near-infrared laser light into any one of a panoply of visible laser colors, including red, orange, yellow and green.

Laser technology: The Turbulence and the Comb
While the light of an ordinary laser only has one single, well-defined wavelength, a so-called ''frequency comb'' consists of different light frequencies, which are precisely arranged at regular distances, much like the teeth of a comb.

A laser for penetrating waves
The 'Landau-level laser' is an exciting concept for an unusual radiation source.

Laser light detects tumors
A team of researchers from Jena presents a groundbreaking new method for the rapid, gentle and reliable detection of tumors with laser light.

The first laser radio transmitter
For the first time, researchers at Harvard School of Engineering have used a laser as a radio transmitter and receiver, paving the way for towards ultra-high-speed Wi-Fi and new types of hybrid electronic-photonic devices.

The random anti-laser
Scientists at TU Wien have found a way to build the 'opposite' of a laser -- a device that absorbs a specific light wave perfectly.

Laser 'drill' sets a new world record in laser-driven electron acceleration
Combining a first laser pulse to heat up and 'drill' through a plasma, and another to accelerate electrons to incredibly high energies in just tens of centimeters, scientists have nearly doubled the previous record for laser-driven particle acceleration at Berkeley Lab's BELLA Center.

Read More: Laser News and Laser Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.