Physicists at Boston University Build First Successful High Temperature Superconductor Lead--Superconductor Successfully Carries Over 13,000 amps

November 18, 1996

(Boston, Mass.) -- A team of scientists at Boston University set a superconductivity record in tests of a new electrical power lead based on high temperature superconducting elements (HTS)--ceramic elements that are superconducting at a temperature of 90 degrees above absolute zero. The team was led by Dr. George O. Zimmerman, professor of physics at Boston University and his colleague Dr. Yehia Z. Negm. The tests were conducted at the National High Magnetic Field Laboratory in Tallahassee, Florida.

The lead is composed of an assembly of 72 ceramic superconducting composites connected to copper and low temperature supeconducting wire. The composites are encapsulated and magnetically shielded by steel spirals. Liquid nitrogen can be used for cooling of the warm end. The lead is designed to conduct large amounts of electrical power to superconducting magnets without transmitting heat from the power source which would interfere with the functioning of the magnets.

During testing, a direct current of 13,200 amperes was fed through a stainless steel pipe with water flowing through it for cooling. Although the pipe became red hot as a result of the current passing through it, the superconducting lead maintained a temperature of between six and forty degrees above absolute zero. The test was the culmination of an international collaboration of private and academic institutions from the U.S., U.K. and Spain. ZerRes of the U.S. and EURUS, an international company, coordinated the project.

According to Zimmerman, "Our lead, made with high transition temperature superconductors, can be cooled by liquid nitrogen. This is vastly more efficient than previous superconducting leads which required cooling by liquid helium--a cooling system which would easily fill a room at a cost $500,000 or more.

"The potential of this technology is enormous," says Zimmerman. "The applications extend to building prototypes of electromagnetic boats, automobiles and elevators. The technology that has been in use requires a tremendous amount of power to keep the magnets cool enough to function properly. High temperature superconducting cables, based on the technology we have developed, have the potential of making these technologies safer and considerably more efficient.

"Right now power is transmitted in cities through 8 inch tubes containing copper wires that are oil cooled," continues Zimmerman. "By replacing the copper wires with superconducting cables, we can replace the oil with liquid nitrogen. With only minor modification to the cooling systems now in use, we would be able to increase the amount of power that can be carried by the cable by a factor of ten."

The Boston University lead was developed for a project of CERN, the European Center for Nuclear Research in Geneva, Switzerland. CERN is in the process of building a Large Haldron Collider which will require millions of amperes to power its superconducting magnets. The accelerator requires the use of high transition temperature superconducting leads to prevent heat leakage which would interfere with the function of the magnets. The Boston University team was one of four working on the project.

Dr. Larry Sulak, chairman of the department of physics at Boston University, applauded the work of the team: "We originally projected a year for the development of the lead, but the team actually built a successful prototype in just three months. It was very exciting to see how well it worked during testing at the Magnetic Field Laboratory."

In addition to the CERN project, the Boston University lead can be used to provide power for Magnetic Resonance Imaging Systems (MRI), and provides a basis for the technology which would allow for generating and transmitting electrical power more efficiently.

Boston University is the third-largest independent institution of higher learning in the United States, with an enrollment of nearly 30,000 students in its 15 schools and colleges. The University offers an exceptional grounding in the liberal arts, a broad range of programs in the arts, science, engineering and professional areas, and state-of-the-art facilities for teaching and research. Located in a city rich in cultural, historical and intellectual attractions, the University, with more than 2,800 faculty members, is one of the nation's preeminent institutions of higher learning.

Boston University

Related Superconducting Articles from Brightsurf:

Rochester researchers synthesize room temperature superconducting material
Compressing simple molecular solids with hydrogen at extremely high pressures, University of Rochester scientists have, for the first time, created material that is superconducting at room temperature.

Topological superconducting phase protected by 1D local magnetic symmetries
Scientists from China and USA classified 1D gapped topological superconducting quantum wires with local magnetic symmetries (LMSs), in which the time-reversal symmetry is broken but its combinations with certain crystalline symmetries, such as MxT, C2zT, C4zT, and C6zT, are preserved.

Skoltech and MIPT scientists find a rule to predict new superconducting metal hydrides
The search for coveted high-temperature superconductors is going to get easier with a new 'law within a law' discovered by Skoltech and MIPT researchers and their colleagues, who figured out a link between an element's position in the Periodic Table and its potential to form a high-temperature superconducting hydride.

Scientists created an 'impossible' superconducting compound
Scientists have created new superconducting compounds of hydrogen and praseodymium, a rare-earth metal, one substance being quite a surprise from the perspective of classical chemistry.

Quantum technologies: New insights into superconducting processes
Superconductors are regarded as promising components for quantum computers, but so far they only function at very low temperatures.

Superconducting wind turbine chalks up first test success
A superconducting rotor has been successfully tested on an active wind turbine for the first time.

New design strategy can help improve layered superconducting materials
Tokyo, Japan - Scientists from Tokyo Metropolitan University have created a new layered superconducting material with a conducting layer made of bismuth, silver, tin, sulfur and selenium.

Controlling superconducting regions within an exotic metal
Researchers at EPFL have created a metallic microdevice in which they can define and tune patterns of superconductivity.

Evidence of anomalously large superconducting gap on topological surface state of β-Bi2Pd film
Hong Ding's group from the Institute of Physics, Chinese Academy of Science reported the superconducting gap of topological surface state is larger than that of bulk states in β-Bi2Pd thin films using in-situ angle-resolved photoemission spectroscopy and molecular beam epitaxy.

Two advances in understanding the role of 'charge stripes' in superconducting mate
In independent studies, two research teams report important advances in understanding how charge stripes might interact with superconductivity.

Read More: Superconducting News and Superconducting Current Events is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to