Rediscovered Apollo data gives first measure of how fast moon dust piles up

November 20, 2013

Washington, D.C. -- When Neil Armstrong took humanity's first otherworldly steps in 1969, he didn't know what a nuisance the lunar soil beneath his feet would prove to be. The scratchy dust clung to everything it touched, causing scientific instruments to overheat and, for Apollo 17 astronaut Harrison Schmitt, a sort of lunar dust hay fever. The annoying particles even prompted a scientific experiment to figure out how fast they collect, but NASA's data got lost.

Or, so NASA thought. Now, more than 40 years later, scientists have used the rediscovered data to make the first determination of how fast lunar dust accumulates. It builds up unbelievably slowly by the standards of any Earth-bound housekeeper, their calculations show - just fast enough to form a layer about a millimeter (0.04 inches) thick every 1,000 years. Yet, that rate is 10 times previous estimates. It's also more than speedy enough to pose a serious problem for the solar cells that serve as critical power sources for space exploration missions.

"You wouldn't see it; it's very thin indeed," said University of Western Australia Professor Brian O'Brien, a physicist who developed the experiment while working on the Apollo missions in the 1960s and now has led the new analysis. "But, as the Apollo astronauts learned, you can have a devil of a time overcoming even a small amount of dust."

That faster-than-expected pile-up also implies that lunar dust could have more ways to move around than previously thought, O'Brien added.

In his experiment, dust collected on small solar cells attached to a matchbox-sized case over the course of six years, throughout three Apollo missions. As the granules blocked light from coming in, the voltage the solar cells produced dropped. The electrical measurements indicated that each year 100 micrograms of lunar dust collected per square centimeter. At that rate, a basketball court on the Moon would collect roughly 450 grams (1 pound) of lunar dust annually.

Comparing the effects on cells from dust and from damaging high-energy radiation from the sun, O'Brien found that long-term dust accretion could diminish the output from shielded power supplies of a lunar outpost more than even the most intense solar outbursts.

Because the threat posed by radiation damage was recognized early on, solar-cell makers fortified their devices against that sort of harm. Yet, "while solar cells have become hardier to radiation, nothing really has been done to make them more resistant to dust," said O'Brien's colleague on the project Monique Hollick, who is also a researcher at the University of Western Australia, in Crawley. "That's going to be a problem for future lunar missions."

The work is detailed this week in Space Weather, a publication of the American Geophysical Union.

Answers from Apollo

Before Apollo 11 blasted off to the Moon in 1969, NASA scientists realized the Lunar Module would likely kick up a large amount of lunar soil on takeoff, potentially coating nearby science experiments with dust. Detachable covers would require either a small explosive or a physical mechanism to remove after the astronauts left, creating more engineering challenges and room for failure.

"Then I asked what I thought was a pretty common sense question," recalled O'Brien. "If we've got to guard ourselves against damage from the lunar module taking off, who's measuring whether any damage actually took place; who's measuring the dust?"

O'Brien proceeded to quickly invent the Lunar Dust Detector experiment as a small add-on device to the larger experiments. Requiring little power and weighing only 270 grams (0.6 pounds), the dust detector reported back to Earth alongside the non-scientific housekeeping data.

"It really got a free ride," O'Brien said.

The detectors flown on Apollo 12, 14 and 15 operated until NASA shut them off in September 1977 due to budgetary concerns. While the detectors worked properly, NASA did not preserve the archival tapes of the data they collected. For three decades NASA assumed the dust detector data had been lost forever, until 2006 when O'Brien heard about NASA's mistake and told them he still had a set of backup copies.

Lunar levitation

Each detector in the experiment had three solar cells, each covered with a different amount of shielding against incoming radiation. By comparing damage to the unshielded and shielded solar cells, O'Brien made his determination that dust, rather than radiation, caused the most degradation to the protected cells.

Previous model-based estimates of lunar dust accumulation assumed the dust came entirely from meteor impacts and falling cosmic dust. "But that's not enough to account for what we measured," O'Brien said.

With no atmosphere for wind, the Moon's soil should be stagnant. However, O'Brien said a popular idea of a "dust atmosphere" on the Moon could explain the difference. The concept goes that, during each lunar day, solar radiation is strong enough to knock a few electrons out of atoms in dust particles, building up a slight positive charge. On the nighttime side of the Moon, electrons from the flow of energetic particles, called the solar wind, which comes off the Sun strike dust particles and give them a small negative charge. Where the illuminated and dark regions of the moon meet, electric forces could levitate this charged dust, potentially lofting grains high into the lunar sky.

"Something similar was reported by Apollo astronauts orbiting the Moon who looked out and saw dust glowing on the horizon," said Hollick.

The idea of levitating lunar dust could soon be confirmed by NASA's Lunar Atmosphere and Dust Environment Explorer (LADEE), launched in September. The spacecraft orbits 250 kilometers (155 miles) above the surface of the Moon, searching for dust in the lunar atmosphere.

While LADEE scours the Moon's atmosphere, O'Brien looks back on a decades-long science experiment that finally has a result.

"It's been a long haul," said O'Brien. "I invented [the detector] in 1966, long before Monique was even born. At the age of 79, I'm working with a 23-year old working on 46-year-old data and we discovered something exciting--it's delightful."
-end-
Notes for Journalists

Journalists and public information officers (PIOs) of educational and scientific institutions who have registered with AGU can download a PDF copy of this early view article by clicking on this link: http://onlinelibrary.wiley.com/doi/10.1002/2013SW000978/full

Or, you may order a copy of the final paper by emailing your request to Thomas Sumner at tsumner@agu.org. Please provide your name, the name of your publication, and your phone number.

Neither the paper nor this press release is under embargo.

Title: Lunar weather measurements at three Apollo sites 1969-1976

Authors: Monique Hollick and Brian O'Brien: School of Physics, University of Western Australia, Crawley, WA, Australia.

Contact information for the authors: Brian O'Brien: Phone: +011 (+61) 04-0839-2401, Email: brianjobrien@ozemail.com.au

Monique Hollick: Phone: +011 (+61) 08-9387-3827, Email: monique.m.hollick@gmail.com

Note: Both authors are located in Western Australia (UTC+8:00)

American Geophysical Union

Related Solar Cells Articles from Brightsurf:

Solar cells of the future
Organic solar cells are cheaper to produce and more flexible than their counterparts made of crystalline silicon, but do not offer the same level of efficiency or stability.

A blast of gas for better solar cells
Treating silicon with carbon dioxide gas in plasma processing brings simplicity and control to a key step for making solar cells.

Record efficiency for printed solar cells
A new study reports the highest efficiency ever recorded for full roll-to-roll printed perovskite solar cells.

Next gen solar cells perform better when there's a camera around
A literal ''trick of the light'' can detect imperfections in next-gen solar cells, boosting their efficiency to match that of existing silicon-based versions, researchers have found.

On the trail of organic solar cells' efficiency
Scientists at TU Dresden and Hasselt University in Belgium investigated the physical causes that limit the efficiency of novel solar cells based on organic molecular materials.

Exciting tweaks for organic solar cells
A molecular tweak has improved organic solar cell performance, bringing us closer to cheaper, efficient, and more easily manufactured photovoltaics.

For cheaper solar cells, thinner really is better
Researchers at MIT and at the National Renewable Energy Laboratory (NREL) have outlined a pathway to slashing costs further, this time by slimming down the silicon cells themselves.

Flexible thinking on silicon solar cells
Combining silicon with a highly elastic polymer backing produces solar cells that have record-breaking stretchability and high efficiency.

Perovskite solar cells get an upgrade
Rice University materials scientists find inorganic compounds quench defects in perovskite-based solar cells and expand their tolerance of light, humidity and heat.

Can solar technology kill cancer cells?
Michigan State University scientists have revealed a new way to detect and attack cancer cells using technology traditionally reserved for solar power.

Read More: Solar Cells News and Solar Cells Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.