Liquid crystal film protects against flash blindness

December 01, 1999

Boston, Mass. ­ Driving into the sun low on the horizon can be temporarily blinding and dangerous, but a new materials application might someday make a windshield that can screen out the continuous glare and still allow the driver to see, according to a Penn State researcher.

"Continuous, non-damaging, but blinding glare is a problem for drivers, welders, optical sensors and communications equipment," says Dr. I.C. Khoo, professor of electrical engineering. "This material can protect both people and equipment from flash blindness."

The material is a sandwich of liquid crystal between two sheets of glass. The researchers mixed the liquid crystal material with a very small amount of a dye -- methyl red -- which enhances the low intensity light stopping ability of the liquid crystal.

Liquid crystals can protect against glare and even laser flashes because they respond to light intensity nonlinearly. As the intensity increases, the liquid crystal lets in dramatically less light. In the past, Khoo used this property to create an optical switch that reacts in a fraction of a nanosecond to a damaging laser intensity by shutting out the light.

However, for some applications, it is necessary to protect against continuous, long term light that is below the level that will permanently damage the human eye or optical sensors, but intense enough so that seeing through the glare is impossible. That is where the liquid crystal optical limiting film has potential applications.

"A welding robot's optical sensors are blind while they are welding," Khoo told attendees today (Dec. 2) at the annual meeting of the Materials Research Society in Boston. "It would be helpful if some vision was available during the actual process."

The sun also creates a glare problem that conventional sun glasses cannot solve and human welders are forced to wear very dark eye protection. Both these applications require that the operators have some vision.

With the advent of lasers, communications satellites and other optical sensors need protection against damage by intense laser light, but they also need protection against intense, continuous light flare or dazzle which can occur both accidentally and intentionally in the form of laser jamming.

"The optical limiting film can reduce light with the intensity of 140 milliwatts to only 5 microwatts," says Khoo. "This is a dramatic reduction in intensity and sufficient to solve the glare problem. The liquid crystal material has a very large dynamic range."

Besides potential use as eye and sensor protection, this liquid crystal can also be used in photographic systems to enable photographers to take pictures even if intense glare would normally fog the film or create light streaks. Khoo believes the material has other applications in image processing as well.

"Some liquid crystals present themselves as promising next generation image processing and optical switching/limiting materials," says Khoo.

Khoo's work is sponsored by the U.S. Army Research Office, the U.S. Air Force and the Naval Air Development Center.
-end-
Editors: Dr. Khoo may be reached at 814-863-2299 orick1@psu.edu.

Penn State

Related Liquid Crystal Articles from Brightsurf:

Materials scientists learn how to make liquid crystal shape-shift
A new 3D-printing method will make it easier to manufacture and control the shape of soft robots, artificial muscles and wearable devices.

A new lens on the world: Improving the metalens with liquid crystal
Case Western Reserve University physics professor Giuseppe Strangi and collaborators at Harvard and the Italian university UniCal have taken a step toward making ''metalenses'' even more useful--by making them reconfigurable.

X-rays indicate that water can behave like a liquid crystal
Scientists at Stockholm University have discovered that water can exhibit a similar behavior like a liquid crystal when illuminated with laser light.

Ultrafast lasers probe elusive chemistry at the liquid-liquid interface
Real-time measurements captured by researchers at the Department of Energy's Oak Ridge National Laboratory provide missing insight into chemical separations to recover cobalt, a critical raw material used to make batteries and magnets for modern technologies.

Liquid crystal integrated metalens for versatile color focus
A research team from Nanjing University recently demonstrated active manipulation of chromatic dispersion, achieving achromatic focusing within a designated broadband.

Crystal wars
Scientists at The University of Tokyo and Fudan University researched the process of crystallization in which competing structural forms coexist.

Melting a crystal topologically
Physicists at EPFL have successfully melted a very thin crystal of magnetic quasi-particles controllably, as turning ice into water.

The makings of a crystal flipper
Hokkaido University scientists have fabricated a crystal that autonomously flips back and forth while changing its flipping patterns in response to lighting conditions.

Crystal power
Scientists at the US Department of Energy's Argonne National Laboratory have created and tested a single-crystal electrode that promises to yield pivotal discoveries for advanced batteries under development worldwide.

Mechanism of controlling autophagy by liquid-liquid phase separation revealed
Japanese scientists elucidated characteristics of PAS through observing the Atg protein using a fluorescence microscope and successfully reconstituted PAS in vitro.

Read More: Liquid Crystal News and Liquid Crystal Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.