Atom-thin transistor uses half the voltage of common semiconductors, boosts current density

December 10, 2020

BUFFALO, N.Y. -- University at Buffalo researchers are reporting a new, two-dimensional transistor made of graphene and the compound molybdenum disulfide that could help usher in a new era of computing.

As described in a paper accepted at the 2020 IEEE International Electron Devices Meeting, which is taking place virtually next week, the transistor requires half the voltage of current semiconductors. It also has a current density greater than similar transistors under development.

This ability to operate with less voltage and handle more current is key to meet the demand for new power-hungry nanoelectronic devices, including quantum computers.

"New technologies are needed to extend the performance of electronic systems in terms of power, speed, and density. This next-generation transistor can rapidly switch while consuming low amounts of energy," says the paper's lead author, Huamin Li, Ph.D., assistant professor of electrical engineering in the UB School of Engineering and Applied Sciences (SEAS).

The transistor is composed of a single layer of graphene and a single layer of molybdenum disulfide, or MoS2, which is a part of a group of compounds known as transition metals chalcogenides. The graphene and MoS2 are stacked together, and the overall thickness of the device is roughly 1 nanometer -- for comparison, a sheet of paper is about 100,000 nanometers.

While most transistors require 60 millivolts for a decade of change in current, this new device operates at 29 millivolts.

It's able to do this because the unique physical properties of graphene keep electrons "cold" as they are injected from the graphene into the MoS2 channel. This process is called Dirac-source injection. The electrons are considered "cold" because they require much less voltage input and, thus, reduced power consumption to operate the transistor.

An even more important characteristic of the transistor, Li says, is its ability to handle a greater current density compared to conventional transistor technologies based on 2D or 3D channel materials. As described in the study, the transistor can handle 4 microamps per micrometer.

"The transistor illustrates the enormous potential 2D semiconductors and their ability to usher in energy-efficient nanoelectronic devices. This could ultimately lead to advancements in quantum research and development, and help extend Moore's Law," says co-lead author Fei Yao, PhD, assistant professor in the Department of Materials Design and Innovation, a joint program of SEAS and UB's College of Arts of Sciences.
-end-
The work was supported by the U.S. National Science Foundation, the New York State Energy Research and Development Authority, the New York State Center of Excellence in Materials Informatics at UB, and the Vice President for Research and Economic Development at UB.

University at Buffalo

Related Graphene Articles from Brightsurf:

How to stack graphene up to four layers
IBS research team reports a novel method to grow multi-layered, single-crystalline graphene with a selected stacking order in a wafer scale.

Graphene-Adsorbate van der Waals bonding memory inspires 'smart' graphene sensors
Electric field modulation of the graphene-adsorbate interaction induces unique van der Waals (vdW) bonding which were previously assumed to be randomized by thermal energy after the electric field is turned off.

Graphene: It is all about the toppings
The way graphene interacts with other materials depends on how these materials are brought into contact with the graphene.

Discovery of graphene switch
Researchers at Japan Advanced Institute of Science and Technology (JAIST) successfully developed the special in-situ transmission electron microscope technique to measure the current-voltage curve of graphene nanoribbon (GNR) with observing the edge structure and found that the electrical conductance of narrow GNRs with a zigzag edge structure abruptly increased above the critical bias voltage, indicating that which they are expected to be applied to switching devices, which are the smallest in the world.

New 'brick' for nanotechnology: Graphene Nanomesh
Researchers at Japan advanced institute of science and technology (JAIST) successfully fabricated suspended graphene nanomesh (GNM) by using the focused helium ion beam technology.

Flatter graphene, faster electrons
Scientists from the Swiss Nanoscience Institute and the Department of Physics at the University of Basel developed a technique to flatten corrugations in graphene layers.

Graphene Flagship publishes handbook of graphene manufacturing
The EU-funded research project Graphene Flagship has published a comprehensive guide explaining how to produce and process graphene and related materials (GRMs).

How to induce magnetism in graphene
Graphene, a two-dimensional structure made of carbon, is a material with excellent mechani-cal, electronic and optical properties.

Graphene: The more you bend it, the softer it gets
New research by engineers at the University of Illinois combines atomic-scale experimentation with computer modeling to determine how much energy it takes to bend multilayer graphene -- a question that has eluded scientists since graphene was first isolated.

How do you know it's perfect graphene?
Scientists at the US Department of Energy's Ames Laboratory have discovered an indicator that reliably demonstrates a sample's high quality, and it was one that was hiding in plain sight for decades.

Read More: Graphene News and Graphene Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.