Single-crystal technology holds promise for next-generation lithium-ion batteries

December 10, 2020

RICHLAND, Wash. - A promising technology under development by major battery makers has become even more attractive, thanks to researchers who have taken an unprecedented look at one key barrier to better, longer-lasting lithium-ion batteries.

Scientists at the U.S. Department of Energy's Pacific Northwest National Laboratory report new findings about how to make a single-crystal, nickel-rich cathode hardier and more efficient. The team's work on the cathode, one critical component in the lithium-ion batteries that are common in electric vehicles today, appears in the Dec. 11 issue of the journal Science.

Researchers around the globe are working to create batteries that deliver more energy, last longer and are less expensive to produce. Improved lithium-ion batteries are critical for broader adoption of electric vehicles.

The challenges are plenty. A battery's simple appearance belies its complexity, and controlling the complex molecular interactions within is essential for the device to operate properly. Constant chemical reactions take their toll, limiting how long a battery lasts and influencing its size, cost and other factors.

The promise of a nickel-rich cathode: More energy capacity

Scientists are working on ways to store more energy in the cathode materials by increasing nickel content. Nickel is on the drawing board of lithium-ion battery makers largely because of its relatively low cost, wide availability and low toxicity compared to other key battery materials, such as cobalt.

"Nickel-rich cathode materials have real potential to store more energy," said Jie Xiao, corresponding author of the paper and group leader of PNNL's battery research program. "But large-scale deployment has been a challenge."

While nickel holds great promise, in high amounts it can pose problems in batteries. The more nickel in the material's lattice, the less stable the cathode. High nickel content can increase unwanted side reactions, damaging the material and making storage and handling very difficult.

Exploiting all the benefits from more nickel while minimizing the drawbacks poses a challenge.

Currently the most common nickel-rich cathode is in the form of polycrystals - aggregates of many nanocrystals in one larger particle. These carry advantages for storing and discharging energy faster. But the polycrystals sometimes break down during repeated cycling. This can leave much of the surface area exposed to electrolyte, accelerating unwanted chemical reactions induced by high nickel content and generating gas. This irreversible damage results in a battery with a nickel-rich cathode that fails faster and raises safety concerns.

Of single crystals, ice cubes and lithium-ion batteries

Scientists like Xiao are trying to sidestep many of these problems by creating a single-crystal, nickel-rich cathode. The PNNL researchers developed a process to grow high-performance crystals in molten salts - sodium chloride, common table salt - at high temperature.

What's the advantage of a single crystal compared to a polycrystalline material? Think of keeping your food cool while camping. A solid block of ice melts much more slowly than the same amount of ice that comes in small cubes; the block of ice is more resistant to damage from higher temperatures and other outside forces.

It's similar with nickel-rich cathodes: An aggregate of small crystals is much more vulnerable to its surroundings than a single crystal under certain conditions, especially when there's high nickel content, since nickel is prone to induce unwanted chemical reactions. Over time, with repeated battery cycles, the aggregates are ultimately pulverized, ruining the cathode's structure. That's not so much a problem when the amount of nickel in the cathode is lower; under such conditions, a polycrystalline cathode containing nickel offers high power and stability. The problem becomes more pronounced, though, when scientists create a cathode with more nickel--a cathode truly rich in nickel.

Cathode's microcracks reversible, preventable

The PNNL team discovered one reason why a single-crystal, nickel-rich cathode breaks down: It's due to a process known as crystal gliding, where a crystal begins to break apart, leading to microcracks. They found that the gliding is partially reversible under certain conditions and have proposed ways to avoid the damage altogether.

"With the new fundamental understanding, we will be able to prevent the gliding and microcracks in the single crystal. This is unlike the damage in the polycrystalline form, where the particles are pulverized in a process that is not reversible," said Xiao.

It turns out that gliding motions within the crystal's lattice layers are at the root of microcracks. The layers move back and forth, like cards in a deck as they're shuffled. The gliding occurs as the battery charges and discharges - lithium ions depart and return to cathode, straining the crystal ever so slightly each time. Over many cycles, the repeated gliding results in microcracks.

Xiao's team learned that the process can partially reverse itself through the natural actions of the lithium atoms, which create stresses in one direction when the ions enter the crystal lattice and in the opposite direction when they leave. But the two actions don't completely cancel each other out, and over time, microcracks will occur. That's why single crystals ultimately fail, though they don't break down into small particles like their polycrystalline counterparts.

The team is pursuing several strategies to prevent the gliding. The researchers have discovered that operating the battery at a common voltage - around 4.2 volts - minimizes damage while still within the normal range of lithium-ion batteries for electric vehicles. The team also predicts that keeping the size of a single crystal below 3.5 microns may avoid damage even at higher voltages. And the team is exploring ways to stabilize the crystal lattice to better accommodate the arrival and departure of lithium ions.

The team estimates that the single-crystal, nickel-rich cathode packs at least 25 percent more energy compared to the lithium-ion batteries used in today's electric vehicles.

Now, PNNL researchers led by Xiao are working with Albemarle Corporation, a major specialty chemical manufacturing company and one of the world's leading producers of lithium for electric vehicle batteries. In a collaboration funded by DOE, the team will research the impacts of advanced lithium salts on the performance of single-crystal nickel-rich cathode materials by demonstrating the process at kilogram scale.
-end-
In addition to Xiao, who is the corresponding author, the first author of the study is Yujing Bi of PNNL. Additional authors are from PNNL, Brown University and Brookhaven National Laboratory. The work was funded by DOE's Office of Energy Efficiency and Renewable Energy's Vehicle Technologies Office. Part of the research was done using the National Synchrotron Light Source II at Brookhaven.

DOE/Pacific Northwest National Laboratory

Related Batteries Articles from Brightsurf:

New research says Sodium-ion batteries are a valid alternative to Lithium-ion batteries
A team of scientists including WMG at the University of Warwick combined their knowledge and expertise to assess the current status of the Na-ion technology from materials to cell development, offering a realistic comparison of the key performance indicators for NBs and LIBs.

Fast calculation dials in better batteries
A simpler and more efficient way to predict the performance of batteries will lead to better batteries, according to Rice University engineers.

Building the batteries of cells
A new study, led by Dr. Ruchika Anand and Prof.

Researchers create a roadmap to better multivalent batteries
Lithium-ion batteries power everything from mobile phones to laptop computers and electric vehicles, but demand is growing for less expensive and more readily available alternatives.

New NiMH batteries perform better when made from recycled old NiMH batteries
A new method for recycling old batteries can provide better performing and cheaper rechargeable hydride batteries (NiMH) as shown in a new study by researchers at Stockholm University.

Seeing 'under the hood' in batteries
A high-sensitivity X-ray technique at Berkeley Lab is attracting a growing group of scientists because it provides a deep, precise dive into battery chemistry.

Better, safer batteries
For the first time, researchers who explore the physical and chemical properties of electrical energy storage have found a new way to improve lithium-ion batteries.

New catalyst provides boost to next-generation EV batteries
A recent study, affiliated with South Korea's Ulsan National Institute of Science and Technology (UNIST) has introduced a new composite catalyst that could efficiently enhance the charg-discharge performances when applied to metal-air batteries (MABs).

New lithium batteries from used cell phones
Research from the University of Cordoba (Spain) and San Luis University (Argentina) was able to reuse graphite from cell phones to manufacture environmentally friendly batteries.

Safe potassium-ion batteries
Australian scientists have developed a nonflammable electrolyte for potassium and potassium-ion batteries, for applications in next-generation energy-storage systems beyond lithium technology.

Read More: Batteries News and Batteries Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.