UTA discovery could reduce cost, energy for high-speed Internet connections

December 15, 2017

Breakthrough research from The University of Texas at Arlington and The University of Vermont could lead to a dramatic reduction in the cost and energy consumption of high-speed internet connections.

Nonlinear-optical effects, such as intensity-dependent refractive index, can be used to process data thousands of times faster than what can be achieved electronically. Such processing has, until now, worked only for one optical beam at a time because the nonlinear-optical effects also cause unwanted inter-beam interaction, or crosstalk, when multiple light beams are present.

An article published in the prestigious Nature Communications journal, by the research group of Michael Vasilyev, an electrical engineering professor at UTA, in collaboration with Taras I. Lakoba, a mathematics professor at UVM, detailed an experimental demonstration of an optical medium in which multiple beams of light can autocorrect their own shapes without affecting one another.

This work, funded by the National Science Foundation, enables simultaneous nonlinear-optical processing of multiple light beams by a single device without converting them to electrical form, opening the way for this technology to reach its full multi-Terabit per second potential, resulting in cheaper and more energy efficient high-speed internet communications.

Currently, to eliminate the noise accumulated during light propagation in optical communication links, telecom carriers must resort to frequent optoelectronic regeneration, where they convert optical signals to electrical via fast photodetectors, process them with silicon-based circuitry, and then convert the electrical signals back to optical, using lasers followed by electro-optic modulators. Since each optical fiber can carry over a hundred different signals at various wavelengths, known as wavelength-division multiplexing (WDM), such an optoelectronic regeneration needs to be done separately for each wavelength, making regenerators large, expensive and inefficient consumers of power.

An attractive alternative to this is processing the optical signal directly, without converting it to electrical and back. In particular, the speed of light propagating in a transparent medium can be slightly modified by a change in the light intensity. This is a manifestation of a nonlinear-optical effect known as "self-phase modulation" or SPM. If light contains both signal and noise, the SPM can help clean the signal from noise by scattering the noise energy into frequencies well outside the signal band, from where the noise can be easily removed by a filter. When applied to light containing useful data, this SPM-enabled noise-removal operation is called "all-optical regeneration," which can result in optical auto-correction of the signals carrying hundred times faster data rates than what can be processed electronically.

However, the adoption of the all-optical regeneration in communication systems has been hindered by its inability to work with WDM signals. This is because in the presence of multiple signal beams, or WDM channels, the desired SPM is always accompanied by two undesirable effects: cross-phase modulation, where one channel's intensity modifies propagation speed of another channel, and four-wave mixing, where interaction of several channels leads to interference with other channels.

In their published article, Vasilyev and colleagues report experimental demonstration of a novel group-delay-managed nonlinear-optical medium, where strong SPM effect is achieved without such inter-channel interference. Splitting a conventional nonlinear medium, such as an optical fiber, into several short sections separated by special periodic-group-delay filters yields a medium in which all frequency components of the same WDM channel travel with the same speed, ensuring strong SPM. Different WDM channels travel with different speeds, which dramatically suppresses any inter-channel interaction.

"Our new nonlinear medium has allowed us to demonstrate simultaneous all-optical regeneration of 16 WDM channels by a single device, and this number has only been limited by the logistical constraints of our laboratory" Vasilyev said. "This experiment opens the opportunities to scale the number of channels to over a hundred without increasing the cost, all in a book-sized device."

The multi-channel regenerator could even potentially shrink to the size of a matchbox in the future if the nonlinear-optical medium could be implemented on a microchip.

"This breakthrough is an example of how UTA researchers can positively impact the physical and economic well-being of society in the area of data-driven discovery and global environmental impact, themes in UTA's Strategic Plan 2020 Bold Solutions | Global Impact," said Jonathan Bredow, professor and chair of the Department of Electrical Engineering in UTA's College of Engineering.

"Previous efforts to implement nonlinear-optical processing, such as regeneration, failed to make an impact because there was no advantage to employing them over electrical signals due to the inability to use more than one channel. Now that Dr. Vasilyev's group has overcome that obstacle, there are tremendous new possibilities for faster, more efficient transmission of messages," Bredow said.
-end-


University of Texas at Arlington

Related Energy Consumption Articles from Brightsurf:

Optimizing of VCSEL photon lifetime for minimum energy consumption at varying bit rates
Prof. Bimberg's group at Bimberg Chinese-German Center for Green Photonics Changchun at Institute of Optics, Fine Mechanics, and Physics, Chinese Academy of Sciences has developed VCSELs emitting at 850 nm, 880 nm, 910 nm, 940 nm, which were optimized to achieve 50+ Gb/s, enabling 200+ Gb/s data transmission across a multimode fiber.

Solar assisted heating networks reduce environmental impact and energy consumption
More than 40% of energy consumption in the European Union is by buildings and 63% of this figure is due to residential dwellings.

First measurement of electron energy distributions, could enable sustainable energy technologies
To answer a question crucial to technologies such as energy conversion, a team of researchers at the University of Michigan, Purdue University and the University of Liverpool in the UK have figured out a way to measure how many 'hot charge carriers' -- for example, electrons with extra energy -- are present in a metal nanostructure.

Long-term developments of energy pricing and consumption in industry
Researchers at the Paul Scherrer Institute PSI have collaborated with British economists to study how energy consumption by Swiss industry develops depending on energy pricing.

Mandatory building energy audits alone do not overcome barriers to energy efficiency
A pioneering law may be insufficient to incentivize significant energy use reductions in residential and office buildings, a new study finds.

A smart way to predict building energy consumption
In a time of aging infrastructure and increasingly smart control of buildings, the ability to predict how buildings use energy -- and how much energy they use -- has remained elusive, until now.

Mapping the energy transport mechanism of chalcogenide perovskite for solar energy use
Researchers from Lehigh University have, for the first time, revealed first-hand knowledge about the fundamental energy carrier properties of chalcogenide perovskite CaZrSe3, important for potential solar energy use.

Space dragons: Researchers observe energy consumption in quasars
Researchers, for the first time, have observed the accelerated rate at which eight quasars consume interstellar fuel to feed their black holes.

New discipline proposed: Macro-energy systems -- the science of the energy transition
In a perspective published in Joule on Aug. 14, a group of researchers led by Stanford University propose a new academic discipline, 'macro-energy systems,' as the science of the energy transition.

How much energy storage costs must fall to reach renewable energy's full potential
The cost of energy storage will be critical in determining how much renewable energy can contribute to the decarbonization of electricity.

Read More: Energy Consumption News and Energy Consumption Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.