Mini-lasers, silicon on sapphire technology lead to speedier chips

December 28, 2001

Using light beams in place of metal wires, engineers at The Johns Hopkins University have devised a cost-effective method to speed up the way microchips "talk" to each other. The method, created by a team in the Department of Electrical and Computer Engineering, takes advantage of unusual characteristics associated with "silicon on sapphire" technology, a new way to manufacture microchips.

"We've developed a very fast and cost-effective way of getting data on and off a chip without using wire," says Andreas G. Andreou, a professor in the department and director of the lab in which the work was done. "It really promises to revolutionize how computer systems for homes and businesses are put together."

Andreou's team relies on the same fiber optics technology that is used to carry phone conversations across great distances. These components are incorporated into a new type of microchip technology. The microchips inside most modern computers are assembled on thin slices of silicon, a material that is a semiconductor. The Johns Hopkins engineers use microchips in which silicon is layered onto thin slices of synthetic sapphire, a material that is an insulator and also allows light to pass through it.

In the microsystem devised by Andreou's team, a signal that originates in a wire is transformed into light and beamed through the transparent sapphire substrate via a laser that is only slightly larger than a human hair. Microlenses and other optical components, manufactured at the same time as the electronic circuits on the microchip, collect the light beam and guide it to another place on the microchip or, using an optical fiber, move it to another chip.

At its destination, the light enters a high-speed optical receiver circuit that transforms the stream of photons into a stream of electrons that continue their journey through electrical wiring connected to other computer components. By using optical signals, or simply an unhindered laser beam, the Johns Hopkins researchers believe a signal could move 100 times faster than it does along a metal wire. Also, the optoelectric interface circuits require much less power because the sapphire substrate is an insulating material, not a semiconductor. This property of the substrate reduces the power dissipation that commonly occurs in modern microprocessors when signals travel through wires that have capacitances, which are parasitic components that not only degrade the signals but also increase the power consumption of the system.

The new design is expected to significantly speed the movement of data between electronic components across a single chip and from one chip to another for a simple reason: "Without the parasitic capacitances, it's much faster to send signals at the speed of light," says Alyssa Apsel, a doctoral student in the Anderou lab who helped developed the system.

Andreou and Apsel wrote about the breakthrough in an article published in the November 2001 issue of "IEEE Circuits and Systems Magazine." Their co-authors were Zaven K Kalayjian, a former Johns Hopkins doctoral student; Phillippe O. Pouliquen, a Johns Hopkins postdoctoral fellow; Ravi A. Athale, formerly of George Mason University and now at the Defense Advanced Research Projects Agency; George Simonis of the Army Research Laboratories; and Ron Reedy of the Peregrine Semiconductor Corp. Also, in the Sept. 13, 2001, issue of the journal "Electronics Letters," Apsel and Andreou reported on this new design and described a high-speed, very-low-power optical receiver that uses this new technology.
-end-
The project was supported by grants from the Army Research Laboratories and the National Science Foundation.

Diagram, technical paper and images of Andreou and Apsel available; contact Phil Sneiderman.

Related Links:
Johns Hopkins Sensory Communication and Microsystems Laboratory: http://olympus.ece.jhu.edu

Andreas Andreou's Web Page: http://olympus.ece.jhu.edu/~andreou/index.htm

Alyssa Apsel's Web Page: http://olympus.ece.jhu.edu/~apsel

Johns Hopkins Department of Electrical and Computer Engineering: http://www.ece.jhu.edu

THE JOHNS HOPKINS UNIVERSITY
OFFICE OF NEWS AND INFORMATION
3003 N. Charles Street, Suite 100
Baltimore, Maryland 21218-3843
Phone: (410) 516-7160 / Fax (410) 516-5251

Johns Hopkins University

Related Semiconductor Articles from Brightsurf:

Blue phosphorus: How a semiconductor becomes a metal
Blue phosphorus, an atomically thin synthetic semiconductor, becomes metallic as soon as it is converted into a double layer.

A new method to measure optical absorption in semiconductor crystals
Tohoku University researchers have revealed more details about omnidirectional photoluminescence (ODPL) spectroscopy - a method for probing semiconducting crystals with light to detect defects and impurities.

Medical robotic hand? Rubbery semiconductor makes it possible
A medical robotic hand could allow doctors to more accurately diagnose and treat people from halfway around the world, but currently available technologies aren't good enough to match the in-person experience.

Laser allows solid-state refrigeration of a semiconductor material
A team from the University of Washington used an infrared laser to cool a solid semiconductor by at least 20 degrees C, or 36 F, below room temperature, as they report in a paper published June 23 in Nature Communications.

Scientists create smallest semiconductor laser
An international team of researchers announced the development of the world's most compact semiconductor laser that works in the visible range at room temperature.

Clemson researcher's novel MOF is potential next-gen semiconductor
Clemson professor Sourav Saha demonstrated a novel double-helical metal organic framework architecture in a partially oxidized form that conducts electricity, potentially making it a next-generation semiconductor.

A gold butterfly can make its own semiconductor skin
A nanoscale gold butterfly provides a more precise route for growing/synthesizing nanosized semiconductors that can be used in nano-lasers and other applications.

Scientists pioneer new generation of semiconductor neutron detector
In a new study, scientists have developed a new type of semiconductor neutron detector that boosts detection rates by reducing the number of steps involved in neutron capture and transduction.

Scientists see defects in potential new semiconductor
A research team has reported seeing, for the first time, atomic scale defects that dictate the properties of a new and powerful semiconductor.

Bending an organic semiconductor can boost electrical flow
Slightly bending semiconductors made of organic materials can roughly double the speed of electricity flowing through them and could benefit next-generation electronics such as sensors and solar cells, according to Rutgers-led research.

Read More: Semiconductor News and Semiconductor Current Events
Brightsurf.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.